open the hood and look in the upper right side of the motor compartment, there you will see a rectangle shape body with brake lines comming out of the back of it. from the top view it looks like a lid with a wire holder securing the top down. with a screw driver place it under the wire and push, slightly pri and lift the wire towards the passenger side that secures the lid. after that remove the lid or cap and fill the resivour.
Just unscrew the cap and pour it in, it is on the drivers side engine compartment, high up on the firewall.
Dot 3 Brake fluid for Clutch master cylinder.ANSWERTurn the engine off before opening the hood.Find the clutch fluid reservoir. It's usually close to the back of the engine, near the brake fluid reservoir.Take off the cap.Check the fluid level. If it is not filled to the top, you will need to add brake fluid. (See "How to Add Brake Fluid to the Clutch Master Cylinder" under Related eHows.)Replace the cap tightly.
Remove the fill cap and add it at the brake fluid master cylinder reservoir. Located on or near the master cylinder.
The clutch master cylinder is high up on the drivers side firewall, next to and slightly farther outward than the brake cylinder, it is the smaller of the two.
The Jeep Wrangler has four seats, as does the Jeep Wrangler Unlimited. There are, however, companies that manufacture a portable third row seat for use in the Jeep Wranglers to add extra space.
Good question. At the brake fluid resovoir
ADD BRAKE FLUID
You open the hood, find the brake fluid reservoir, take the cap off and add DOT 3 brake fluid up to the full level.
You can add brake fluid inside the brake fluid reservoir. The reservoir is located on the driver's side under the micro-filter panel.
Locate the brake fluid reservoir, and pour brake fluid in until it's at the appropriate level.
Brake fluid reservoir is located on the firewall next to the steering column. Remove cover top of master cylinder to add brake fluid.
It does not make a difference if the car is hot or cold when you add brake fluid.