Want this question answered?
A Yamaha Blaster not going into gear is typically a sign of an issue with the clutch. To troubleshoot, try to adjust the clutch at the lever. If this doesn't solve the problem, the shot clutch pack may need to be replaced.
there should be 6 clutch plates
Well cable could be froze up. Replace the clutch cable. If cable is working adjust cable. If the clutch cable is adjusted then it's time for a new clutch
Buy a yamaha blaster manual. Shows you step by step picture by picture.
7. the answer is 7
Yamaha Blaster Inner Clutch Spring Torque(5 Bolts with Springs) 4.3Ft-Lb. (51.6In-Lb.) Also, Center Bolt 5.1Ft-Lb. (61.2In-Lb.)
How do you adjust tbe clutch on a yamaha vstar
To adjust a clutch on a 2005 Yamaha V Star Classic, pull the clutch lever slightly and loosen the large lock nut on the cable adjuster. Twist the cable clockwise and adjust the cable's tension until there is only 1/8 inch of free play at the clutch lever.ÊÊÊ
It is located on the right side of the engine and is the most forward part of the clutch cover
you cant adjust a drive belt, you problem is in the secondary clutch, I am sure you need to replace the sliding clutch and put a spacer in front of the hub.
the plates are round with a cork like coating on the outer surface about 3/4" wide
23.67 ozs and I use Spectro Clutch Saver 10W 40