your brake master cylinder serves as your slave cylinder resevior. If either your master or slave clutch cylinders are going bad, it may not do any good to try to adjust them. But the slave cylinder has a bleeder screw and the process of bleeding the clutch is similar to bleeding the brakes. In short, open the bleeder screw when clutch is being pressed, and close it when clutch is fully pressed. Have a tube on the bleeder screw going into a jar of brake fluid so you can see bubbles coming out of the slave. The slave is mounted on the bottom of the transmission and the master clutch cylinder is on the firewall behind and below the battery, it has a tube that goes to the lower right rear of the master brake cylinder reservoir to get it's fluid supply.
location cylinder 2 mazda protege
The slave cylinder for your hydraulic clutch is located inside the manual transmission bellhousing
In the stem of the chair.
The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing
If it does not have a Hydraulic clutch, then it has no fluid. If it has a Hydraulic clutch the clutch master cylinder is normally located on the firewall, driver's side, near the brake master cylinder.
Can be reached from the trunk
The clutch master cylindar should be right beside the brake master cylindar. I have run across a couple of cars that have the brakes on the passenger side but never the clutch. I assume this holds true for your car. As far as adjusting a hydraulic clutch, they don't. If the clutch is not pushing in enough, it is usually the slave cylindar which is located on the bell housing of the transmission. They get worn and need to be replaced.
The slave cylinder for your hydraulic clutch is located inside the transmission bell housing
The slave cylinder for a hydraulic clutch is located inside the manual transmission bellhousing
Follow the hydraulic hose from the clutch master cylinder. The other end attaches to the slave cylinder.
my 1998 4 cylinder protege is under left of air filter right of engine I think.
The Fuel filter is located on the firewall, next to the brake master cylinder and right behind and below the carb.