Depending on the size or the bit and the chuck, you can use a "collar " on the bit. Make one out of something that will slide firmly onto the outside of the bit. like the plastic tube from inside a ball point pen, a piece of aquarium tubing, etc. You can also buy 1/4" shank bits with small diameter ends. They are made to use in power screwdrivers, but will work in your drill. Hope this helps !
ANS 2 -When I have this situation I use a 'pin drill' which is essentially a 1/4 steel tube with a 'collet' on the business end that holds tiny drill bits. -I simply fit the shaft of this 'pin drill' into my bench drill's chuck.
If there are 3 holes on the side of the chuck you use a chuck key. If there are no holes, you turn the end 2/3's of the chuck and hold the bottom 1/3.
The size of the chuck is the only limitation. Most bench drills have a 1/2 chuck and many of them are removable. -ie,you can often fit a bigger chuck.
The function of tang is to fit in the chuck.
Depends on the chuck. Adjustable chucks can be loosened by hand, simply twist the end of the drill. Older (or heavy duty drills) need a key to open the drill chuck. I have a McKeller cordless 18V electric drill with no hand adjustable or key adjustment visable???? I'm confused
Use a pair of Vise-Grip pliers on the key-less chuck and Channel-lock pliers on the stuck bit. Holding the drill with the drill facing away from you (as in use), turn the chuck clockwise and the bit counterclockwise.
A hand drill can be various things, such as an old fashioned S shaped drilling device that you turn by hand, or a straight drill with a geared wheel which you turn to rotate the bit. In more modern terms,a hand drill is aa electric motor in plastic case that has a chuck in front of it where you can fit drill bits and have the motor turn the bit at high speed.
15mm drill bit and a drill.
Yes it will fit, but the collet will have to tightened down quite hard to grip it.
you need a pull choke cable to use it manually and then set it so when closed you can fit an 1/8" drill bit between the carb body and the choke flap.
A 20mm or 13/16 drill bit will allow the bolt to fit through.
It's a plain old ordinary drill that will fit in a conventional drill chuck.They specify that now so it doesn't get confuse with all the new types. (Hex, SDS, splined etc.)
Bit is a small but useful word. Like drill bits, which fit on the end of a drill to change its function, the word bit has several uses. Usually, it means a little piece of something, even time.
Grinders and drills are not for cleaning tiles. At the most aggressive level you may want a rotary wire brush to fit in your drill.