If the door is hangging low and hard to close. You will need to replace the door bushings, once the they wear out the door is allowed to sag. Hope the answered your question.
In a 1988 Chevy pickup the ECM is located behind the glovebox.
There is no choke to adjust.
you need: fuel compression and spark
I have a 1988 chevy s10 pickup 2.8. I went to the service department at my local chevy dealership and they printed out 3 diagrams for me for free.
There should be adjustment screws located along the sides of the headlamps themselves. You may have to take the bezels off of the headlamps to get at them (but I don't think so).
Yes but modification will be needed
The 1988 Chevy K 2500 pickup truck has a listed gross vehicle weight of 4360 pounds. The gross vehicle weight does not include any fluids.
behind the drivers seat.
The 1988 Chevy C/K Series pickup truck has a fuel capacity of 25 gallons. The C/K Series was sold in the United States from 1960 to 1999.
In a manual for that vehicle.
YES, They are the same engines. That would be a direct bolt in.
YES, All the cabs are the same from 1988 to 1999
disconnect the battery for a few minutes
its in the tank so the tank must come out
From 1988 to early month of 1999 will work.
Yes it is the same fender.
1988 to 1999 are all the same.
That was LATE 1999 when Chevy changed the body style. From 1988 to late 1999 the bodys were the same.
The 1988 Mitsubishi pickup truck data link connector is located on the bottom of the drivers side dashboard. The gauge link connector will be to the left of the steering column.
The drivers side is the odd side, #1 is in front.
It is behind the distributor, and screewed into the top of the engine block
my a/c sticker is gone under the hood.how much Freon goes in my system.1988 regular cab,v8?
how do you set timing on 88 s10 2.5? ?
Just beneath the drivers side door, behind the frame.