Look down in the console in the slot the e-brake lever comes you will see a 10mm nut just tighten it up to remove all the slack Caution do not over tighten this nut or you will break the cable just tighten it enough to remove the slack if it feels like it doesn't want to turn anymore than stop there. If you still have lots of slack than you have a frozen cable
You can adjust your 1989 Chevy Corvette emergency brake into different ways. The emergency brake will have an adjustment bolt on the brake pad. The emergency brake cable can be adjusted to shorten or lengthen the cable.
The emergency brake cable is connected to the brake shoe on the rear brakes. You can adjust the emergency brake by loosening or tightening the nut on the end of the cable.
In the center arm rest is a cover at the bottom that can be removed to expose the emergency brake cable, and a nut to adjust the tension.
You can find a diagram of the emergency brake cable and adjustments on a 2001 Escort Zx2 in the owner's manual. You can also find it at various auto part retail stores.
brake cable needs to be replaced or adjusted
The 2005 Jeep Grand Cherokee emergency brake cable has adjustment nuts on each end of the cable. Turn the adjustment nut to lengthen or shorten the cable.
you must first adjust the rear drum brakes. then and only then can you adjust the cable for the parking brake at the base of the park brake pedal/handle. if you don't do the rear drums first, you will stretch the cable
http://wiki.answers.com/Q/Adjust_emergency_brake_cable_on_2002_GMC_yukon"
it is a self ajustment each time you put hand brake it is done
there should be an adjusting nut on the e- brake line If this is a disc brake e-brake there is a Alan wrench adjuster behind the brake piston of the caliper located by the brake cable braket. Unscrew the bolt and insert an Alan wrench. Turn right to tighten, or left to loosen. Drum brakes have a 10 mm nut under the plastic cover over the lever This connects directly to the cable lefty loosey deep socket helps
The emergency brake cable is held in place with swivel nuts on each end of the cable. Turn the swivel nuts to the left. The emergency brake cable will come off.
You have to take them all off from pedal to wheel and re-fit as a set, then adjust them.