Assuming the parking brake is a similar style to that on my 1995 Prizm, this is a very easy fix. Start by removing the center shrowd which surrounds the parking brake. There will be screws holding it in place on either side in the front, as well as underneath the carpet in the little storage area. Once all fasteners are out, with the help of a screwdriver you can pry this shrowd off. The brake handle attatches to the end of a wire with two nuts: the bottom one adjusts the brake (right/tight, left/loose) and the nut on top locks the lower one in place. After fidgiting with it for a few minutes, you should be able to figure out how tight to make it and be able to reassemble the cover.
To tighten the emergency brake cable on a 1990 Geo Prism, start by depressing the brake pedal. Next, locate the parking brake equalizer bar. Rotate both rear tires to feel the brake shoes slightly drag against the brake drum.
pull the parking brake lever up hard. providing your cables are good and functional the shoes will expand and the adjuster inside will reset.
Yes the Geo Prism has ait bags.
in the fill resivor attached to the master cylinder assembaly
usually all you need to do is use a timing light and rotate the distributer
The break light switch is located on the backside of the break peddle arm.
GM made a small car called the geo prism. GM Chevrolet or GEO
where is the fuel filter located on a 91 geo prism?
on my sons 95 prism i had to loosen the nut on the brake light switch and turn it in a couple turns then retighten the nut, works fine
Check the bulbs - they are double filamented with the smaller being for the brake lights Check for a blown fuse Check the operation and alignment of the stoplight switch
Same answer as: "How do you replace a starter on a 92 Geo Prism LSI or GSI?" at this same site.
try your public library buy a haynes manual 15.00 bucks