Its probibly is the bolt between the pump and pulley that hard to see. To access it use a thin wrench or a socket, place it through the opening of the pulley. Tighten that plus the pivot bolt. Might be a third bolt behind the pump. Hope this helps
the power steering pump is on the top left of the engine , i think it's the highest point of the serpentine belt route.
The SuperChip i installed in my 1990 oldsmobile toronado trofeo gave it 25hp more according to the dyno.
You will probably need to replace power steering hose-I have owned several toronados and generation two bodies with 307 v8 always leak at power steering hose eventually-especially with high miles-replacing hose always worked for me. When this hose leaks it tends to get fluid on belts making them squeel
I've been working on an 85 Oldsmobile with a V8 and I replaced the power steering pump. There are about three holes on the pulley itself, line one of the holes up with a nut on the other side of the pump and loosen to move the pump along a bracket.
The power steering is not adjustable.
how to replace the power steering hose on a 2001 oldsmobile aurora 3.5 liter engine
power steering fluid or ATF III
were is the power steering pressure switch on a 1988 oldsmobile cutlass 2.8 engine
On a 1997 Oldsmobile 88 LS the power steering reservoir is on the firewall side of the engine. It is near the passenger side of the engine compartment.
Word the question properly. What is an Oldsmobile Royale?
Your power steering pump is likely defective.
Remove the 1998 Oldsmobile power steering pump hose. Remove the power steering pump retaining bolts. Reverse the process to install the new power steering pump.