0
1, Remove the rubber cap off the end of the bleed valve. Fit a clear vinyl tube over the bleed screw and put the other end in a container of clean brake fluid.;
2. Have a helper push the clutch pedal several times, then hold to the floor.
3. Loosen the bleed valve to let the air out of the line. When it quits bubbling tighten the bleed vavle. The clutch gets its brake fluid from the brake master cylinder. Check it to make sure it stays full during the bleeding process.
4. Repeat steps 2 and 3 until you don't see bubblels anymore.
5. Close the bleed valve and put the rubber cap back on.
6. Check the clutch that it works OK. If not bleed it again.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Does a 1998 ford escort have a clutch cable?
I'm not a mechanic / technician but I would say ( no ) It is a hydraulic clutch on a 1998 Ford Escort The BRAKE FLUID RESERVOIR is also the CLUTCH FLUID RESERVOIR
How can you bleed a Rover 400 1998 hydraulic clutch?
The Hydraulic clutch fitted to the rover 400 is a sealed unit and the only thing that you can do is to replace the complete unit
How do you change a clutch cable on a 1998 integra?
You don't. There is not a clutch cable on a 1998 integra. It has a hydraulic clutch.
Is your clutch hydraulic or cable its a 1998 fiesta 1.8 diesel?
Run car at idle and press / depress clutch. If RPMsfluctuate it's hydraulic.
How do you adjust a clutch on a 1998 Honda civic si?
You can't, it's self adjusting hydraulic clutch.
Does a Honda Prelude 1998 type sh have a cable or hydraulic transmission?
I think you mean hydraulic clutch. I believe your model is hydraulic.
Where is the bleeder for a hydraulic clutch on a 1998 escort?
The bleeder is located at the clutch arm on the bell housing. There is a fluid line going from the master cylinder to the clutch bleeder. This metal line has flexible hoses at either end. Follow this line down to the front of the engine just about in the middle and you'll find the bleeder valve.
How do you bleed a 1998 Dodge Ram 1500 clutch system?
If you look hard enought there is a way to bleed the clutch but its a whole process....,they come pre bleed from the factory so theres no manufacture instructions
How do you adjust a clutch on a 1998 suzuki intruder?
The Suzuki Intruder has a hydraulic clutch and therefor there is no adjustment.... There is an adjustment on the clutch lever for the distance from the grip, that is all...
Why wont AC clutch engage on 1998 escort ZX2?
Most Likely Low With Freon.
How do you change a master cylinder for a 1998 Chevy S10?
How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?
Is clutch of freelander 1998 hydraulic or cable?
Hydraulic Master, slave, and pipe work are all one unit individual parts are not available for the freelander.
