Many GM clutches of the era are not bleed-able.
The clutch hydraulics may not be serviceable, replace as set only.
fd
how do you bleed a cluch on a 92 Saturn sl
No,It is ahydraulic clutch, try to bleed the unit first and see if that helps.
How do you convert the ac in a 1992 Chevy lumina
I HAD THE SAME PROBLEM WITH MY 92 WRANGLER.. GO TO AUTOZONE.COM AND CLICK ON SERVICE MANUALS, THEY WILL EXPLAIN HOW TO BLEED THE SLAVE CYLINDER.. AND IT WORKS.. DON DRC@EPIX.NET
there is no alternator on the 1992 Lumina its all electric, so there is no need for one.
The Chevy lumina does not have an inertia switch.
There is a bleeder on the drivers side. It is on the side of the block. You have to hold the bleed and twist the top part. Its just like bleeding brakes too so you will need another person to help you.
you just bleed it like the brakes pump the clutch pedal 6 or 7 times hold to the floor and have someone open the bleeder screw on the tranny tighten and repeat until al the air is out of the slave i think its on the driver side of the transmission make sure u fill ur fluid before and after u bleed it
just like you bleed your brakes. pump the clutch pedal and hold it down, open the bleeder screw and let the air/ fliud release and then tighten it up again. repeat the process till the air is out, and keep an eye on the fluid and keep it topped up! dont let it go empty.
Hopefully you mean a 1992 Lumina, and yes, most starters are standard.
I have a 92 lumina euro that did that and it turned out to be my crank sensor. The problem could also be the Torque Converter Clutch, bad plugs and wires, distributer cab, low idle could cause this to.