Best Answer

There should be a radiator drain plug on the bottom corner of the radiator. (varies on which side) You'll probably have to remove some of the plastic skid plates on the bottom to get at it. Or if you want, just remove the lower radiator hose from the radiator and let it drain that way.

To bleed a cooling system means to purge air out of it. Just take the radiator cap off and let it run for a short time. the excess air will come out.You may have to replace coolant .

User Avatar

Wiki User

โˆ™ 2012-08-27 02:07:54
This answer is:
User Avatar

Add your answer:

Earn +5 pts
Q: How do you bleed your cooling system ford escort 1993?
Write your answer...

Related Questions

How do you bleed cooling system of 1993 Mercury Villager?

There is no need to do this normally.

How do you bleed the air out of a 1993 Lumina Z34 cooling system?

You'll need a vacuum pump that is used by AC service technicians.

How do you bleed air from a 1993 ford probe gt cooling system?

To bleed air from the cooling system, take off the radiator cap and let the engine run. IF there is no radiator cap(some vehicle manufacturers have done away with them, just add coolant to the overflow tank to the correct level. The cooling system will purge air out on it's own

How do you add brake fluid to the slave cylinder in a 1993 Escort?

You don't. You add it to the master cylinder and bleed the brakes.

Are the 1993 3.8 liter Chrysler known for over heating?

Only when there is a failure in the cooling system.Only when there is a failure in the cooling system.

How do you prime the cooling system on a 1993 Toyota Previa?

By using water

Will a transmission from a 1993 escort fit a 1997 escort?


Show ac diagram for 1993 Ford Escort?

show 1993 ford escort ac diagram

How would you get an air lock out of your heatercore in a 1993 Grand am?

Use the bleeder valve to bleed the system.

Where can you find a schematic for a 1993 Chevy Cavalier wiring and cooling system?

You can find a 1993 Chevrolet Cavalier schematic diagram, for the wiring and cooling system, at most Chevrolet dealerships. You can also find the diagram at most auto-parts stores.

How do you get the air out of the cooling system on a 1993 silverado?

Park the truck so the front end is raised or jack it up, to get the radiator opening higher than the heater core. Then bleed the system normally by filling and running, heat on high, until thermostat opens. Then refill and top off.

Will a 1995 escort bumper fit a 1993 escort?

Yes they are interchangeable and identical.

Will 1993 Taurus parts work on a 1993 Escort?

None will work.

Why does the temperature gauge act erratic goes from cold to hot quickly then drops to cool on a 1993 mercury villager?

Can be a defective temperature sending unit. If you just chance the coolant can be air trapped in the cooling system. You would need to bleed all air from the system. Can also be a defective gauge, but highly unlikely.

What do you need to do if the rear brake caliper on a 1993 grand prix will turn but not compress?

Replace the caliper and bleed the brake system.

Where is the egr valve located on 1993 Ford Escort?

The 1993 Ford escort did not come with an EGR valve. It is one of a few year models that do not have one.

Where is the Timing chain on a 1993 ford escort?

The timing chain for a 1993 Ford escort is located on the front of the engine. It is under the timing chain cover.

Where is the turn-hazard signal relay on a 1991 Ford Escort?

see answer for 1993 escort

Can an 1993 escort 1.9L engine fit in a 1995 escort?

Yes, they are the same engine design.

What is the firing order for a 1993 Ford Escort LX?

The firing order for a 1993 Ford Escort LX with a 1.9 engine is 1-3-4-2

What type of freon in cooling system on a Buick Century?

1993 and before it is R-12, 1994 and later its R-134a

What type of freon in cooling system on a buick lesabre?

1993 and before it is R-12, 1994 and later its R-134a

Will a transmission from a Ford Escort 1993 fit a 1995 Escort?

Yes it will as long as it is the same motor size. If it is the escort LX it is a 1.9 litre engine. If it is the escort GT it is a 1.8 litre.

How do you reset computer on a 1993 Ford Escort?

To reset the computer on a 1993 Ford Escort, you will need a OBD-1 scanner. Once this is obtained, you will be able to initiate a restart of the computer.

What part in the cooling system can fail between the engine and transmission on a 1993 ford aerostar?

3.0 Liter V6: freeze plug