try pulling the fuse out
A starter solenoid can be bypassed by connecting a jumper wire between the battery and ignition posts on the starter. This will cause it to spin immediately without using the ignition switch.
in the 2008 dodge caliber it seems like you cannot. My brother did in fact disconnect the battery...quess what, it worked. after connecting it back, the system reset and off they went.
run the wire that goes in the battery directly to the positive side of the batt.problem solved
Take out the battery.
Starge wired to battery
bypass it by connecting the battery cable directly to the starter motor. remember the solenoid is just a low voltage switch which exists so that high current cables do not have to be run to the starter system. wheni you turn the ignition key it should activate an electro-magnet in the solenoid which causes a metal bar to connect the battery power to the starter motor. so just bypass it to prove whether it works or not.
Neutral switch
Unplug the battery, and wait 10 minutes to plug it back up.
If I was you I would disconnect the battery.
take out cmos battery for 2 min
No, it is commonly done when heater core goes south.
Sometimes this is due to NAT type 3. You get this when connecting your PS3 Via wi-fi. But there is a way you can bypass this, you enter the PS3 ports into your router.