0
How do you bypass the angle bank sensor on a 1995 harley Davidson sporster?
Wiki User
∙ 14y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the speed sensor on a 2003 Harley Davidson FLHTCUI?
On the tranny.
Where is the sensor for a 95 harley Davidson digital speedometer?
a 95 harley does not use a digital speedometer. If urs has one, it is probably aftermarket modificiation.
Where is the speedometer sensor on a 2000 harley Davidson ultra classic located?
on top, right side of trans
Where is the speedo sensor on a 1998 harley Davidson Dyna Wide Glide Evo engine.?
on the bike somewhere
Where is the bank angle sensor located on a harley Davidson?
It's under the seat and bolted to the rear fender.
What effects will a bad cam sensor have on a harley Davidson 883 sportster?
wont fire, timing off, backfiring
Where is the speedometer sensor on a 2003 harley Davidson road king?
top right side of the transmission, toward the rear.
Is there a speedometer sensor on a 2000 harley Davidson ultra classic?
If you don't have a speedo cable on your front wheel, you have a speedo sensor. I believe that change was made in 2000.
How do you replace speed sensor on a 2000 Harley Davidson flstf?
Info on the Road King Forum about it...http://forums.delphiforums.com/Live2Ride/messages?msg=35643.2
Will a 2006 Harley Davidson sportster exhaust fit a 2007 Harley Davidson sportster?
Unfortunately not: The 07 Sporties are EFI (fuel injected), thus requiring o2 sensors (and sensor bungholes) in the exhaust. 06 bikes, on the other hand are use a cv carb that does not need the sensors or bungs.
How do you clean Harley Davidson speedometer sensor?
The speedometer sensor is lovande On rop tight of the tranny, loosen The vilt and lift The sensor up, there should be a O-ring so be careful when you lift it up! then sand The sensor genre and clean it carefully. Done!
Where is the ignition module on a 2001 harley davidson sportster?
On 98-03, it is integrated with the cam position sensor inside the nose cone on the right hand side of the engine.
