answersLogoWhite

0


Best Answer

Open the clutch master cylinder reservoir and empty it. Then open the slave bleeder screw. Pull the clutch handle several times, fluid should come out. It may not be desirable to change or remove all the fluid in one operation as you would then have to remove the unbolt and remove the entire slave cylinder. But if you do unbolt this unit, then you can use a screwdriver to push the piston back as far as it will go o remove fluid that is trapped inside it. Leave the slave cylinder in a hanging position on the hose to drain the fluid as well as you can. Then fasten this unit in its place on the engine. Next step, make sure the fluid reservoir of the master cylinder is full of fluid. Then follow this procedure to bleed the clutch for air:

Press the lever in

Hold lever in

Open the bleeder screw so air can pass out to the vent

Close the bleeder screw

Release the lever

Pump the lever a few times

Hold and press the lever in

Open the bleeder screw for a few moments

Close the bleeder screw again

Release the handle

Wash all areas that come into copntact with the clutch fluid with soap water. You may have to repeat the procedure until there is no air in the system. The top banjo bolt may also be bled. Press the clutch lever in for about three-fourths of the way it will move, hold it back and then open the briefly open the banjo bolt to allow fluid and air to escape, then tighten the banjo bold. You can now release the clutch lever. Be careful not to pump the lever with the bleeder open as you will then cause an airlock in th system and will then have to bleed it again. The same goes for the banjo bolt procedure.

User Avatar

Wiki User

10y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change 1996 Honda 1100 shadow hydraulic clutch fluid?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Can you adjust a clutch on 1987 Honda shadow 1100?

If there is a hydraulic master cylinder at the clutch lever (looks like the front brake) then...NO.


Is there a cable to the clutch of a 1996 Honda Accord?

No the clutch is hydraulic.


Does Honda Accord have a hydraulic clutch?

Depends on the year. All Accords' made after 1989 have a hydraulic clutch.


Does 86 Honda Prelude have clutch cable?

The 1986 Honda Prelude does not have a clutch cable. The 1986 Prelude has a hydraulic clutch instead of the clutch cable.


What type of clutch does a 2005 Honda civic have?

hydraulic single disc clutch


Does a 1991 Honda Prelude have a hydraulic clutch?

Yes it does


How do you adjust clutch on 84 750 Honda shadow?

If it is hydraulic, there is no adjustment, just make sure no air is in the line. If it is cable, then there should be a screw at the clutch lever which will tighten the cable. If the clutch really slips, then, well, plates will have to be replaced.


Does a 1986 Honda shadow have a wet clutch?

Yes, it does.


What kind of fluid do you put in the clutch of a 2001 Honda Passport?

it uses the same for the hydraulic clutch as it does for the brakes.


How do you adjust a clutch on a 1998 Honda civic si?

You can't, it's self adjusting hydraulic clutch.


Does a Honda Prelude 1998 type sh have a cable or hydraulic transmission?

I think you mean hydraulic clutch. I believe your model is hydraulic.


How do you convert a cable clutch to a hydraulic clutch in a Honda?

www.hasport.com has clutch master cylinder adapters. Here is the info from their page: "The new master cylinder adapter allows the use of a Honda-style or Wilwood clutch master cylinder to convert a cable transmission vehicle to a hydraulic setup."