I have not changed one on an Aurora, however, I have changed other types and they all seem similar. Usually getting at them is the hard part. You will remove 2-3 bolts, 1-2 vaccum lines,sometimes a metal tube, clean off the old gasket and reverse the procedure.Before I would replace one, I would spray(soak) it with 'DEEPCREEP' made by the SEA FOAM company. Most EGR valves stick because of carbon build-up and this product will dissolve carbon. It may require a couple appications. I hope this helps you. Mark
Where is the speed sensor located on a 1997 Oldsmobile Aurora
Where is the Knock Sensor located on a 1996 Oldsmobile Aurora?
Are there any major differances between a 1996 and 1997 Oldsmobile Aurora
hold the engine reset button in until it resets
7 1/2 qts. with filter change.
on blinker switch
235/60/16
like disk brakes
Parking/tail/dash fuse
How to replace computer box on a 1996 oldsmobile silouethe
A warning light on the dash would illuminate.
It is on the passenger side, right above the headlight.