hi there. huggydan@Yahoo.co.UK.
to change a drive shaft on a clio...
first undo the centre bolt on the drive shaft.this will be in the middle of the weel and will need to be done whilst the car is on the ground as it will be vft..then carefully jack the car on the sill checking it doesnt bend,also use an axle stand for security..
remove the wheel.
undo the pinch bolt on the bottom arm.
using a large bar, pry down on the arm, (the bar should lock in some where.) and at the same tap the bottom ball joint with a hammer, the hub should the separate from the bottom arm,
pull the hub/mcphearson strut outwards.leaving the drive shaft behind because you have all ready undone the drive shaft nut..
with a clean drain tray under the gear box.pull on the drive shaft firmly and the shaft should pop out..then the gear box oil will drain into the container..
install new shaft in reverse order been carefull not to crimp the seal on the gear box as this will result in an oil leak..
once the shaft is installed. with a filler on the top of the gear box.carefully poor the drained oil back in to the gearbox..
ok, good luck.and if you get stuck please email me. ...danni...
yes you terd
Pay a professional
the torque is F.T. [f***ing tight] onset
how do you change a dashboard bulb in a renault clio?
its underneath the car plugged into the gearbox at the side of the nearside drive shaft. mine is blue
It's part of the driveshaft outer cv joint. Replace the shaft as per 2002 Clio 1.5dci
The Renault Clio was produced from the years 1990 to present. The way that the camshaft diamond marking should be pointed on a Renault Clio 2004 are that the long tips should be facing towards the top and bottom.
Renault Clio Renault Sport was created in 1999.
Renault Clio was created in 1990.
Ecu fuse where is on the renault clio
The year when the Renault Clio was available for sales was 1990. The Renault Clio is produced by the french automobile manufacturer Renault.
You can change the fuel pump in Renault clio 1.2 by opening the fuel pump gauge and inserting the fuel pump there. This is a simple process relatively speaking.