Hi,the fuse box is located by the throttle pedals on your right side just after the driver's door.
this really isn't an answer but i have tried to locate where the 12 volt fuse is with no luck, i have searched the owners manual and there is nothing listed as 12 volt or accessory or accy. please somone find out
Where Is fuse to cigarette lighter honda accord euro,and No of fuse in box
The 1992 Honda accord cigarette lighter relay switch can be found behind the dashboard in the passenger compartment. The relay switch will be on the drivers side of the dashboard.
check your fuses.
No, the engine does not have to be running for the cigarette lighter to work. The ingition key must be in the Accessory position (2 clicks) before the cigarette lighter will work. Hope this helped.
There are two fuseboxes for 2006 Honda Accord. The cigarette lighter one is located inside the car on driver side labeled "fusebox", not the one under the hood. Open the correct one the diagram is on back of cover. It is #9, 15 Amp, labeled "FR ACCS". There is no label says "cigarette lighter" on any Honda cars.
To change Honda jazz cigarette lighter socket fuse you need to disconnect the 2P connectors from the cigarette lighter (A) and cigarette lighter light (B) (if equipped).Inspect the connector terminals to be sure they are all making good contact.
The specs for the fuse box should be in the user's manual. (For my 1994 Honda Accord EX, the fuse for the lighter as well as the radio is under the hood)
I bought a used Honda CRV LX 4WD. And the cigarette lighter was not in there. I feel there is no cigarette lighter in this model.
i have 98 Honda accord, has three fuse boxes. look on passenger side of dash.( lower) Also, one on the drivers side. (Lower) . These should be pull open panels
IT is number 9 you're welcome if u need help it will be located on one of the pages
You have to remove the entire center console and the pop up the gear shift box (ver carefully) you then connect the wires and screw the cigarette lighter in.
Need ti get in behind the dash and turn the base till it tightens