Under the hood - drain or soak up the brake fluid in the reservoir, remove 4 nuts/bolts to pull the A/C hose out of the way (tie it off), remove the plastic reservoir, disconnect the fluid line from the master cylinder (m/c). From inside the car - pull the pin that connects the rod to the clutch pedal, remove the 2 nuts that are holding the master cyl in place. Manipulate the m/c and rod and pull it out toward the engine compartment - it may require some force. If you rebuild it, make sure you hone it out and clean before assy. Try to adj the rod the same for fine tuning later - it will make it easier. Reverse for installation.
How do you change a Master Cylinder and hydraulic clutch line for a 1998 Chevy S10?
Mine is a cable clutch so there is no slave cylinder. But if yours is a hydraulic clutch then it should be located on the firewall on the driver side close to the master cylinder.
How to change a clutch and master cylinder on a 93 jeep wrangler
Open the hood, and take a look at your firewall. If it has a clutch master cylinder its a hydrolic. If you only see your brake booster and thats it, chances are its a cable clutch. But as a basic rule, if you have a master and slave cylinder it is hydrolic.
At least the slave cylinder. The clutch master cylinder can be replaced at any time.
im sure this is on the clutch pedal itself.
The master clutch cylinder is attached to the clutch pedal. When one depresses the pedal hydraulic fluid is forced from the master cylinder through the hard line to the slave cylinder. The piston in the slave cylinder is driven against the clutch linkage thereby releasing the clutch.
Remove clutch cable connection and then remove slave cylinder line from master. Then unbolt slave master and remove it. Follow same procedure in reverse order.
The clutch pedal assembly has a clutch rod that pushes in on a clutch master cylinder. There is a hydro line that goes from the master cylinder to the slave cylinder.
The clutch master cylinder is in the engine compartment and the slave cylinder for the hydraulic clutch is inside the manual transmission bellhousing
Which part do you want to replace? The slave cylider or the master cylinder? The hydraulic line and master cylinder.
how do you bleed the clutch master cylinder in a 2005 mazda 3