Geo Storm
Nissan Pathfinder
Timing Belts and Chains
Citroen Saxo

How do you change a fan belt in a 1991 Geo storm?

272829

Top Answer
User Avatar
Wiki User
2008-05-29 07:52:13
2008-05-29 07:52:13

There is no fan belt; the fan is electric. See the question/answer about changing a serpentine (alternator) belt. You may need to remove the passenger side engine splash shield before you can reach the alternator bolts from below. I just work from above to avoid crap falling down into my eyes as I'm looking up, but I also don't have an A/C compressor in my way.

For a VIN "6" engine (the 1.6L SOHC) loosen the alternator hold-down bolt (nearer the firewall, above the alternator), loosen the alternator pivot bolt, move the alternator towards the engine, take off the old belt and put on a new one. Set a reasonable tension on the belt and re-tighten the bolts.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

look into chiltonsonline.com or get yourself a haynes repair manual at any autopart store.!

User Avatar

where do you add manuel transmission fluid on a 1991 geo storm 5 speed

User Avatar

I think that after you put on the timing belt alighned properly,that your distrib. makes up the diff. when you adjust it. Jim

User Avatar

Timing Belt.... Check all your belts.

User Avatar

Follow the pos battery cable. It is at the end.

User Avatar

the alternator and belt are located at the bottom of the engine on the passenger side looking at the timing belt side

User Avatar

the belt only goes around the crank pulley and alternator pulley

User Avatar

This might be helpfful. How do you Change a fan belt on 94 prizm?

User Avatar

Any commercial repair manual will show you the diagram for both single and dual overhead cam models.

User Avatar

rear of engine compartment near the bulkhead

User Avatar

Fuel pump is in the gas tank and it is not cheap.

User Avatar

there is no pilot bushing/bearing for the Geo Storms '90-'93 manual transaxle.

User Avatar

Would have been built for R12, can be converted to R134a.

User Avatar

Remove it an drop it into a pan of boiling water to see if it opens

User Avatar

It's located right behind the tank for the headlight fluid.

User Avatar

Knowing the firing order can help a person troubleshoot engine problems. The firing order for a 1991 Geo Metro is 1-3-4-2.

User Avatar

# 1 is closest to the timing belt and furtherest from the transmission.

User Avatar

plug the wire in on the driver side of the car and 4 bults in it

User Avatar

it si in the relay panel on the passenger side of the engin comp.

User Avatar

On the 1.6L sohc starter is between the engine and fire wall. By the oil filter.

User Avatar

airbag sensor and iat sensor are not the same thing... wiki

User Avatar

My 1991 Geo Prizm LSI does not have overdrive My 1991 Geo Prizm LSI does not have overdrive


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.