answersLogoWhite

0


Want this question answered?

Be notified when an answer is posted

Add your answer:

Earn +20 pts
Q: How do you change a fuel pump on a Mazda mx-3?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the fuel pump relay for the 1993 Mazda MX3 1.8L K8 v6?

in engine bay fuse board


Where is the fuel pump on a Mazda mx3 1993located?

The fuel pump on Mx3 is located under the back seat, just pull it off its holded by clips, then you will be able to remove the small metal cover to access the fuel pump, you dont need to remove the tank from the car although its easier to work on.


How does the fuel regulator on a Mazda mx3 work?

By regulating the fuel pressure


Why does your 1995 Mazda mx3 fuel burp apon axcel?

Change your spark plugs. Bosch super plus.


Where is the inertia switch on a 1993 Mazda mx3?

A 1993 Mazda MX-3 does not have an inertia switch. If anything is wrong with what would normally be the inertia switch, the fuel pump may be faulty.


How to replace a fuel filter on the 1994 Mazda mx3?

its on the fire wall


How do you change the thermostat on a 1993 Mazda mx3?

waste of time


Where is the fuel pressure regulator in a 1993 Mazda mx3?

The fuel pressure regulator is located on the fuel rail of the vehicle.


Where is the fuel filter located on a 92 Mazda MX3?

Under the back seat


Why does the Mazda mx3 die when turning right and low on fuel?

Your Mazda MX3 might die when turning right and low on fuel because of a damaged or bent float in the fuel tank. It might also die because of clogged fuel injectors or a clogged fuel filter that becomes more obvious when fuel is low.


Where is the fuel pump on a 94 Mazda mx3 located?

look underneath the rear seat, the access panel is right there, just undo the four screws, lift the plate and then remove the little screws around the top of your fuel pump. It should pull out easily


How do change brake pads on Mazda mx3?

well i just changed the brakes on my Mazda mx3 what you do is take the 2 pins out of the calipers which is holding the pads in place and then you are able to remove the pads