I actually just did this last night on my aurora....There may be a better way to do it, but here is what I did. 1. Take off the license plate. 2. Remove the 4 bolts from the plate with the reverse lights in it and pull it away from the car (don't need to detach it.) 3. If you look up at the top of the space you just opened you should be able to get to the lights. Each bracket has 2 bolts that need to be removed. 4. Twist each bracket to release the bulb and then just pull the old bulb out and put the new one in. 5. Reverse your steps to put it all back together again :) Btw, if you haven't looked it up yet, you need to buy 2 194 bulbs. Luckily, they come in packs of 2 and cost around $5 total.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
Same circuit/fuse as the parking/tail lights.
change bulbs in gear selector of 2001 oldsmobile aurora
Key on Engine off Step on the gas pedal three times within five seconds.
A warning light on the dash would illuminate.
key on engine off...push gas pedal to the floor 5 timrs witin 3 seconds ..this will turn your lite out
i would have the light switch checked to see if it is faulty
mine on my 97 is on the rear window deck.
it is located above the gas pedal almost under the steering wheel
The light is built into the bumper on that car. Just above the plate.
Fuse and/or switch Switch located at upper end of brake pedal under dash
Read the codes. Then fix the problem. Autozone will read the codes for you for free.