answersLogoWhite
Serpentine Belts
Chevy Venture
Dodge Ram
Ford Escape XLT

How do you change a serpentine belt on a 2000 Dodge Ram 2500 pick up?

8910

Top Answer
User Avatar
Wiki User
2009-07-07 02:42:46
2009-07-07 02:42:46

Take a breaker bar and a socket make sure it's the right size socket for the bolt on the tensioner, insert the socket on the bolt and take the tension off the belt and remove make sure you remember the routing so you can replace as you put it back on pull on the tensioner so you can slip the belt back on then when you have it in let the tensioner go and take the socket out and you should have just changed you belt.

1

Related Questions

User Avatar

how do you change a thermostat on a 2004 dodge ram 2500 series

User Avatar

You can remove the old serpentine belt on your 2004 Dodge Ram by loosening the tensioner pulley. Put the new serpentine belt on and tighten it with the tensioner pulley.

User Avatar

Reman will be around 2000-2500 for the partReman will be around 2000-2500 for the part

User Avatar

A three jaw puller, a serpentine belt tool, and sockets/wrenches.A three jaw puller, a serpentine belt tool, and sockets/wrenches.

User Avatar

a pully underneath the alternator moves with an end wrench. turn the nut clockwise and the belt will loosen up

User Avatar

How do I change a water pump on 1998 dodge ram v10 2500. I need a picture to

User Avatar

The throttle position sensor on a 2000 Dodge Ram 2500 Diesel is located on the right hand side of the carburetor. This location is on the driver's side of the motor.

User Avatar

i have a 2000 dodge ram 2500 quad cab and cant figure out how to adjust rear doors to be a little more tight. thank you,72fj

User Avatar

When repairing a car it is important to know the costs of the repairs. To rebuild a 2500 Dodge Transmission it could cost between $2000 and $4000.

User Avatar

On my 2000 Dodge 2500, there is a fuse box under the hood, and the fuse is a blue 20 amp.

User Avatar

The payload capacity for the 2000 Dodge Ram 2500 diesel 2x2 with the long bed is 3550 pounds. This is the largest payload capacity for this series of vehicle.

User Avatar

A retaining clip holds the ignition switch in place on the back of the ignition cylinder on your 2000 Dodge Ram.

User Avatar

Dodge does not use inertia switches. The fuel system is computer controlled with relays.

User Avatar

It will be on the side of the automatic transmissions.

User Avatar

if this is a diesel, it is the easiest water pump to change remove serpentine belt remove water pump. install new pump reinstall serpentine belt pump is on front of engine just left of fan as you stand in front and look at engine

User Avatar

It was built with two batteries, yes.

User Avatar

how to change the serpentine belt on 2003 Chevy express 2500

User Avatar

A 2000 Ram does not have EGR. The last 5.9L to have EGR was 1995.

User Avatar

An eight feet bed of a 2009 dodge will fit a 2006 dodge 2500 with a little moderation.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.