Chevy Blazer
Water Pumps
Chevy Blazer S-10

How do you change a water pump in a 1998 Chevy Blazer and is it a do-it-yourself job or too hard?

91011

Top Answer
User Avatar
Wiki User
2005-11-18 18:18:18
2005-11-18 18:18:18

I could not get mine out so I took it to moter specialist

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer

User Avatar

buying a chilton or haynes repair manuel for the s series blazer will help in knowing how to change it

User Avatar

The water pump on a Chevy Blazer 4.3l is on the front of the engine. The Fan and fan shroud will have to be removed to gain access.

User Avatar

I believe i used only a 15 mm wrench when I did one a few years back.

User Avatar

To change water pump on a 1995 Blazer, disconnect theรŠnegative battery terminal. Empty the coolant and unfasten the water pump. Replace with aรŠnew one. รŠ

User Avatar

How do you change the water pump on a 1997 chevy malibu?

User Avatar

when i turn my truck off water leaks from the bottom all the time

User Avatar

replace water pump 2005 chevy trailblazer vortec 4200

User Avatar

no it not hard it should be the pulley the fan is bolted to. I changed mine a couple of weeks ago

User Avatar

It should be located on the front of the water pump.

User Avatar

as in most chevys starter, water pump, and altinator

User Avatar

The average cost to replace your 1997 Chevrolet Blazer water pump is $230. The water pump will cost approximately $80 and require two hours of labor.

User Avatar

how to take off the clutch fan in 96 blazer,trying to change water pump?

User Avatar

It is the part that the fan bolts to, on the front of the engine GOOD LUCK

User Avatar

Follow the top radiator hose down to the water outlet on the engine. The stat is in there.

User Avatar

If you look at the front of the engine, you will see the fan and that is what the fan is bolted to.

User Avatar

Dead center on the front of the engine. Probably has a big fan attached to it.

User Avatar

how do you change a pump water on a 2004 Chevy truck k2500 hd

User Avatar

If it is a v-6, I would say the intake manifold to head connection.

User Avatar

It is at the lower end of the top radiator hose within the water outlet. I hope this helps you. Mark

User Avatar

Your 1983 Chevy S10 Blazer might stall when the accelerator pedal is depressed because of a clogged or dirty fuel filter. Gas that is mixed with water or condensation from the tank can also cause this issue.

User Avatar

Drain the blazer radiator. Refill with water. Open the heat on high, start the engine for a few minutes. Drain the system again Repeat this several times to get all of the old coolant out.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.