Alternators
Honda Accord
Honda Accord LX

How do you change an alternator belt on a 1986 Honda Accord?

232425

Top Answer
User Avatar
Wiki User
2006-08-13 16:57:35
2006-08-13 16:57:35

Air conditioner drive belt needs to be removed to access the alternator belt. Loosen the alternator pivot bolt and the alternator adjustment bolt-the one which rides in a slot. There is a third bolt, like an eyebolt, which points to the rear and has a nut which can be tightened to pull the eyebolt and adjustment bolt. The eyebolt will likely have rusted threads and should be lubricated before starting the job. With the alternator belt off, run the nut over the full length of the eyebolt, then apply grease to the threads. Adjust eyebolt to swing alternator to front of car; the drivebelt can be then easily installed. Tighten nut on eyebolt for correct belt tension, then tighten other two bolts. There is almost no room available to do any of this; sometimes you can't even get one click of a ratchet; that is why it is important to have free-turning hardware.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

the cost of the Honda accord in 1986 is $34995

User Avatar

A 1986 Honda Accord has a 2.0 litre four cylinder engine

User Avatar

The alternator on a 1986 Honda Civic is located in front of the engine. Unplug the battery and remove the alternator belt. Loosen the alternator bracket and remove the plug to the alternator. Replace the unit.

User Avatar

my Honda accord has auto 4 speed that will not shift

User Avatar

You will need to remove the tire and wheel from your 1986 Honda Accord. Remove the brake caliper and the brake spring. The disk brakes will come off. Reverse the process to install the new front disc brakes.

User Avatar

no the 85 and 86 accords are totally different body styles

User Avatar

Most Honda's have an internal, non-serviceable filter that is only changed when the transmission is rebuilt. Call a Honda dealer to be sure.

User Avatar

Seriously, Just don't. You will ruin it.

User Avatar

Screwed onto the engine block.

User Avatar

I have a 1986 Honda Accord Hatchback LXI and the laoyout is printed right on the door opening to the fuses.

User Avatar

1986 Honda Accord starter is located on the passenger's side, on top of the transmission, under several cooling system hoses. Follow the positive cable from the battery and it will lead you to the starter. Drew

User Avatar

how do you change oil in Honda spree

User Avatar

Honda never put a 2.2 liter motor in any of it's cars in 1986.

User Avatar

The fuel control cutoff unit, in your 1986 Honda Accord, is located on top of the fuel injector pump. The fuel control cutoff unit is contained in a sealed box.

User Avatar

My 1986 Honda Accord Dx just started idling rough and dieing at turns and stops it is a carburated 2.0 witha maunal transmission

User Avatar

no the whole top end is different ,and if your buying the injection stuff new ,it would be cheaper to do a engine swap.

User Avatar

how to change oil in a 1986 honda gold wing motorcycle

User Avatar

The answer is no it won't fit. You need an air intake box from a 1986-1989 Accord.

User Avatar

Would have been built for R12, can be converted to R134a.

User Avatar

Take the lock off the glove compartment it has the number on it.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.