0
Loosen the bolt at the top of the caliper assembly (should be a 1/2 or 9/16). Pull the assembly down. If its hard, just tap it at the top with a hammer or pry it off with a flathead screwdriver. Remove the old brake pads and compress the caliper with a c clamp. Install the new pads and raise the assembly back into place. Tighten the bolt and you're done. Note: start with the side under the master cylinder. There should be no need to add any brake fluid. Just pump about 5 or 6 times omce you finish.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Is a 91 Nissan pickup interchangeable with a 93 Nissan pickup?
I would have to say yes BUT what part are you changing?? You can change the engine if you want but it is hard.
Why do my brakes lock up on my 93 Nissan pickup?
Your e.brake cable is stuck on your secondary brake shoe,your cable probaley is bad.
Is the transmition out of a 93 Nissan pickup with the same specs compatible with a 95 Nissan pickup?
no,the specs. are not the same.
Will a auto-trans out of a 87 Nissan fit a 93 Nissan pickup same motor 2.4?
No
Replacing a starter on a 93 Nissan pickup?
Need to know what size engine you have in order to answer your starter problem. 1993 Nissan pickup with v-6
Why front brakes getting hot while driving?
i have a 93 nissan and the front brakes are getting hot when driving
Need a diagram of a 1993 Nissan truck automatic transmission with overdrive?
where is nissan 93 pickup overdrive relay
Where is the headlight relay on a 1996 Nissan 2.4 liter pickup?
On My 93 pickup it , you have to remove the battey and its is just inside the fender. Rick
Where is the fuel filter on a 93 Nissan pickup?
passanger side engine compartment right next to the shock tower
Is a 93 Nissan pickup 4cyd and 6 cyd transmission interchangeable?
no,you cant swap a 4 cylinder and a 6 cylinder out,totally different.
Why does my 93 Nissan d21 pickup 4-cylinder hesitate while driving?
Air/fuel filter? Timing chain sloppy? Fuel pump?
What size Allen wrench is used to change the brakes 93 Bonneville?
I think that one is a 3/8 Allen.
