Want this question answered?
== ==
i have a 1998 grand cherokie 5.9 how do i remove the pulley what tool do i use
it is down by the crank pulley
Remove the drive belt, remove the crank pulley (need a special puller for this), remove the plastic shield, and finally remove the two bolts that secure the sensor to the engine. This is all done through the passenger side wheel well with the wheel removed.
Loosen the 18mm bolt about 4 or 5 mm and give the bolt a good wack and the pulley should pop. Then remove the bolt and pulley.
12 valve engine: front above the crank pulley 24 valve engine: behind the starter.
The Crank sensor in my 91 LeSarre Limited is behind the Harmonic balancer pulley....there are fins on the back of the pulley that line up with the sensor.
hi there, these vehicles have a problem with the crank pulley flogging out on the crank... causing incorrect valve timing.. this is mainly due to the incorrect torque being applied to the crank bolt during the timing belt change.. i have seen numourous examples of this in my trade.. hope this helps..
3.8" inches
what engine??
The crankshaft is in the lower part of the block. The connecting rods, flywheel, and crank pulley all bolt to it.
It is located behind the crankshaft pulley and requires the pulley to be removed to change it out.