what engine??
You can change the serpentine belt by loosening the tensioner pulley. When the tensioner pulley is loose and the serpentine belt will become loose. Put the new serpentine belt on and tighten the tensioner pulley.
You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.
Begin by loosening the tensioner pulley. Slide the tensioner pulley to the right and the belt will become loose. Remove the old belt and put the new belt on. Tighten the new belt by sliding the tensioner pulley to the left.
The 1998 Dodge Dakota tensioner pulley will be the top pulley on the left-hand side of the engine. The tensioner pulley will be able to slide back and forth.
The Serpentine Belt needs to be tightend with the tensioner pulley (Idler Pulley)
Use a chain wrench around the pulley and a breaker bar on the bolt.
Using a 14 mm wrench, loosen the bolt in the center of the tensioner pulley, then tighten the tensioner bolt with the same wrench. Then re-tighten the bolt in the center of the tensioner pulley when the belt is tightened to your liking.
Yes. on the pulley for sure. Maybe the pump too. preasure the dealer.
All these here should be replaced as per post somewhere else: timing belt, water pump, tensioner, tensioner pulley, and idler pulley
Disconnect the battery. Using a metric socket and a breaker bar turn the tensioner clockwise and release the belt. Using a metric socket take off the bolt in the middle of the pulley. Use a pulley puller and pull it off.
See if your local library has a professional shop manual to look at for free... dave
Well, its black and wraps itself around the smallest pulley on the alternator.