Use a chain wrench around the pulley and a breaker bar on the bolt.
yes
What tools do you need to remove the crankshaft pulley on a 1995 Honda Passport?
Depending on engine displacement in general remove belt-s then bolt holding pulley to the crankshaft then using a puller remove the pulley, when installing use a installer not a hammer to put the pulley on the crankshaft.
u need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removalAnsweru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal Answeru need to buy new pulley then, remove serpentine belt from engine remove bolts that hold pulley to crankshaft remove pully instalation is exact opposite of removal
The crankshaft pulley unbolts from the harmonic balancer. The harmonic balancer can be removed from the crankshaft with a 3 bolt puller.
Hello! The crankshaft position sensor is located behind the crankshaft pulley,on the left side facing the front of the car.It is difficult to see and to remove it you need to remove the crankshaft pulley ( radiator,belts,.... )
Remove crankshaft pulley& ballance
Counter Clockwise
Disconnect the battery and remove the fan assembly and crankshaft belts. Remove the center bolt from the pulley and use a crankshaft pulley remover to pull off the pulley. You can usually borrow one from an auto parts store.
1998 Nissan pathfinder crankshaft pulley bolt is right handed.
Depends on what type of vibration damper (crankshaft pulley) you have. Your local auto parts store probably has the one you need and can rent it to you.
disconnect negative battery cable rotate the engine in the normal direction of rotation(clockwise)until the no.1 is TDC remove the accessory drivebelt loosen the water pump pulley bolts and then remove the water pump pulley using a chain wrench or a strap wrench to hold the crankshaft pulley,loosen the crank pulley bolt and then remove the pulley bolt and the crank pulley.Make sure that you dont move the No.1 cylinder from TDC while loosening the crank pulley bolt.After removing the crankshaft pulley remove the timing belt retainer/guide flange remove the 4 upper timing belt cover bolts and then remove the upper timing belt cover.Remove the lower timing belt cover bolts make sure that the timing belt camshaft sprocket timing marks are aligned with the top of the cylinder head if your planning to re-use the timing belt put a directional arrow indicating the normal clockwise direction of rotation on the belt remove the timing belt tensioner pulley bolt and then remove the tensioner pulley remove the timing belt remove the timing belt idler pulley bolt and then remove the idler pulley if the camshaft sprocket is damaged or must be removed to replace the camshaft seal or to strip the cylinder head for overhaul use a wrench to hold the cramshaft in place and then remove the sprocket retaining bolt.Then remove the camshaft sprocket from the end of the camshaft remove the crankshaft tioming belt sprocket