Determine if it is LEFT or RIGHT hand thread, Do this by, Start motor and see which way fan turns, The fan will always turn in the direction that you need to turn the nut. If top goes toward left side of truck then turn the nut toward the left. and other for right. ,,,,,,,,,,,,,,,,, They make A special tool for removing the nut.,,,,,,,,,,,,,,,,,,,,,,,, If you have a air hammer, You can use it to turn the nut by putting it on the nut toward the side you want the nut to turn and hammer it with the tool. ,,,,,,,,, Use the tool to lightly snug the nut when you put on the new clutch, You do not have to tighten it a lot.
It doesn't use a fan clutch. It has electric cooling fans.
Using a special clutch fan tool to hold the fan still, remove the fan nut and take the fan off of the dodge 360. The tool should be available for rental from a local auto parts.
If Possible Get rid of your Clutch Fan and go Electric! But to answer the question, remove serpentine belt and use a strap wrench to stop clutch from spinning when you try to remove fan clutch nut from water pump!
The wench will be used to remove the clutch fan nut. Remove the nuts holding the fan then remove the fan blade.
A Hayden is $135 from Advance Auto or $70 from Ebay
Take belt off water pump pulley remove fan from pump (4 bolts) remove old clutch from fan install new with same bolts Put fan back on.
How do you change a fan clutch on a 1991 bmw528i?
12mm wrench on the four bolts behind it
Does anyone know how to take off a radiator fan clutch from a 1998 Dodge Dakota 3.9 V6
The fan clutch is a mechanical viscous drive and does not have a relay.
When can turn the fan freely with no resistense
Check clutch fan