Remove wheels Re-install 2 lug nuts to hold rotor in place Remove 2 caliper mounting bolts Slide caliper off rotor Use a "C" clamp to fully retract piston into caliper body Install new inner and outer pads Re-Install caliper REMEMBER TO PUMP BRAKE PEDAL TO SET PADS AGAINST ROTOR PRIOR TO MOVING VEHICLE
howdo you change the front axel of a dodge Dakota 2000 4x4
replace front brake rotors and pads.
how do i change to front brakes on a dodge durango?
Master cylinder. Located on the firewall, driver's side, in front of the brake booster.
Hub Knuckle
Jack up The Dakota and remove the wheel. Unbolt the caliper and slide it off, being careful that the hose does not get damaged. The brake pads can be slid from the caliper and replaced at this point.
1992 dodge dakotas do not have front coil springs, they have torsion bars instead.
Lift the car, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Put in the new brake pad, replace the brake shoe/caliper, replace the tire and lower the car to the ground.
Sticking brake calipers. This can be caused by moisture in the brake fluid which will cause the calipers to rust. Replace the calibers and replace all the brake fluid. It can also be caused by driving with your foot on the brake.
If memory serves, 18mm. That would be the bracket bolt. The caliper bolt has a 9mm thread.
The Dodge Intrepid has front and rear brake hoses
Unless the calipers are frozen- you will have a slight drag as the brake pads maintain contact with the caliper