Want this question answered?
The front wheel bearings need to be pressed into the spindles. This is something an automotive machine shop would normally do. The rear wheel bearings are bolt-on hub assemblies.
The front wheel bearings must be pressed into and out of the spindle/hub assembly. You will need to take the spindle assembly to an automotive machine shop to have this done.
My front wheel bearings just went in my 04 mountaineer, and we tried to replace them ourselves, but in order to get to the bearings you have to have the truck up on a lift, so unfortunately we had to send it to a mechanic.
The distributor in a Mercury Villager is the round thing at the front of the engine with the six spark plug wires attached to it.
mercury mariner
Front wheel drive
Bottom front of engine.
It is on the front of the engine on the end of the crankshaft.
In front of the engine, down in the "V".
To change a CV Axle on a 1998 Mercury Villager, take off the front tire and the caliper assembly. Take off the pad and the rotor. Disconnect the steering knuckle and pull the CV axle off. Replace with new and reinstall the parts.
At the front of the motor attached to the engine cradle.
The front wiper arms on a 1997 Mercury Villager clip off once they are bent backwards. To install the new wipers simply slide them into the clip.