I had the same problem and the owners manual said to take to the dealer. For a burnt out bulb? I looked on the internet and found several methods, this is the one I felt most comfortable with and worked for me.
OK, open the hood, manually raise the headlight on the side the marker light is on, by cranking the knob on the headlight motor. Remove the screws for the headlight shroud and remove. Loosen the jam nut for the hood support just enough so you can unscrew it and remove, then you are able to reach down in an squeeze the clip and turn the socket at the back of the marker light and separate it from the housing, and replace the bulb. The difficult part is getting the socket back in the housing. You can see all this until you stick your arm in there. Once you have your arm in there it is all done by feel.
how do you replace a bulb in a fog light on a 2000 maxima?
how do you change the light bulb over the license plate on 2000 eclipse
You have to take the whole light out, there is two screws to take out, then the light will pull out. Then change the bulb. Greeny
Change the bulb and check to see if it's not grounding out.
ho change the head light bulb in a 2000 ford f- 150
light bulb out on map light how to change with out breaking plastic lens
Looks like a 2057. See sources and related links below to view entire light bulb list for the 1984 Chevrolet Corvette.
cant change bulb will need to change the the light as well get one from scrapyard will cost about £5
The daytime run lamps are your high beam bulbs with a module that cuts the amount of amperage that just dims the bulbs. Just change high beam bulb.
Just unscrew the rear brake light, turn out the socket, and replace the bulb.
Open the hood, get to the back of the light, remove the rubber cover and the light is visible. Turn the light bulb housing and pull the bulb out. Installing is the reverse.
Could you please narrow down what lightbulb?