0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you change a rear axle seal on a 2004 ford escape?
how t change rar axle seal on 04 ford escape xlt
How do you change a rear axle seal on a 2003 gmc 2500 hd sierra?
Remove the tire and wheel from your 2003 GMC 2500 Sierra. Remove the end of the axle. Using a seal puller remove the axle seal. Reverse the process to install your new rear axle seal.
How do you replace a Ford F-150 rear axle seal?
how do you replace a Ford F150 rear axle seal
How do you change rear axle seal in a 2002 Chevrolet Silverado?
First, remove the axle. Then, user a large screwdriver or a seal remover to remove the seal. Tap a new seal into place with a hammer. Reinstall the axle and fill the differential lubricant.
What can leak on a rear drum brake?
Brake wheel cylinder or axle sealBrake wheel cylinder or axle seal
How do you change axle seal on 2006 Saturn Vue?
Remove the tire and wheel. Remove the axle end cap. Remove the axle seal with a seal puller. Reverse the process to install the new axle seal.
How do you change rear axle seals on 1988 suburban?
YOU WILL HAVE TO PULL THE AXLES OUT IF IT IS HALF TON MODEL. THIS IS DONE BY REMOVING THE WHEELS AND BRAKE DRUMS FIRST. THEN THE REAR AXLE COVER WILL HAVE TO BE REMOVED. REMOVE SPIDER GEAR CROSS SHAFT. SLIDE IN AXLES, REMOVE C CLIPS AND PULL OUT AXLES, YOU WILL NEED A SLIDE HAMMER OR SEAL PULLER TO REMOVE OLD SEALS, CHECK OUTER AXLE BEARINGS AND AREA ON AXLE FOR DAMAGE OR WEAR. CLEAN UP AXLE AREA WHERE SEAL RUNS AGAINST WITH EMORY CLOTH. COAT AREA WITH AXLE GREASE AND REINSTALL. BE CAREFUL NOT TO DAMAGE NEW SEAL WHEN SLIDING AXLE BACK IN. REINSTALL CLIPS AND SPIDER SHAFT.PUT COVER BACK ON AND INSTALL PROPER GEAR LUBE. INSTALL DRUMS AND WHEELS.
How do you replace right rear axle seal on 1992 Buick roadmaster?
buick roadmaster 1992 rear axle does it have limited slip diff
How do you replace the seal on a rear axle on Ford Aerostar 1996 van?
What type of rear end do you have?
What is the part number for a 1967 Chevelle rear axle seal?
The rear outside axle seal on my 1968 Chevelle has on it's outside face, the number 3832418. I am not sure if GM uses this same number for their parts inventory, but the manufacturer of the seal does.
Why do rear brakes grab on 1999 suburban?
probably the return spring(s) are broken or the brakes are contaminated (gear lube from leaking axle seal) or if it hasent been used in a while they could be rusty.
How do you change a rear main seal on a 350?
how do you change a rear main seal in a Chevy 350 motor
