First, there should be a diagram of the serpentine belt and pulley system on the top of the radiator fan cowling. If there is not, make one b/4 you remove yours--just draw the pulley arrangement first. Then examine how the belt comes off the pulley, draw the "weave" pattern of the belt through the pulleys and double check one last time. At this point, you can cut the belt off or take one last opportunity to examine the pattern as you remove/slide the belt off by relieving the belt tension using the tension adjustment bolt behind the Power Steering pump.
How to change a clutch and master cylinder on a 93 jeep wrangler
A 1993 Jeep Wrangler needs approximately 6 quarts of oil for an oil change.
how to replace the slave cylinder on a 1993 jeep wrangler
The correct factory tire size for a 1993 Jeep Wrangler is 215/75R15.
The windshield streaming after a radiator change on a 1993 Jeep Wrangler is a result of a loose connection. Steam is caused when coolant leaks onto the engine and is heated rapidly.
serpentine belt loose
How do you change the steering shaft in a 1990 Jeep Wrangler?
no it will not, the frame is slightly smaller in the earlier jeeps
how to change the windshield wiper motor in a 2000 jeep wrangler
yes
A ratchet isÊneeded to loosen the serpentine belt tension pulley on a 2002 Jeep Wrangler V6. It will require a 1/2 inch ratchet.
no, they are entirely different vehicles