on the top of your motor (looking at it from the front) follow your intake manifold witch should be square large and in plain sight, should say the engine size\manufacture find the throttle body attached to intake look for cables and vacume lines across from them should be a black box looking sensor with a three wire connector and two or three screws possibly locktyte was used in installation careful not to strip them in any case this part is your TPS(throttle position sensor) it has a linkage of some sort that runs either partialy or completely through the plenium most of these sensors are not adjustable but some are i do not believe Chevy has used these adjustable types in some time as it is cost effective to just buy new. hope this helps good luck
The throttle positioning sensor is located in the throttle body.
on the throttle body.
The throttle position sensor is on the throttle shaft, on the throttle body.
change your throttle positioning sensor located on the intake manifold
Could be the Throttle Positioning Sensor or the Idle Air Control Valve
The throttle position sensor is mounted on the side of the throttle body
On the throttle body attached to the throttle butterfly shaft.
the sensor is black an it is on the side of the throttle body at throttle plate!!
the throttle position sensor is located on the side of the throttle body
on the throttle body on the throttle body
there are many different things that it could be check the camshaft positioning sensor, the throttle positioning sensor, and the crankshaft positioning sensor.
Here is a link... With pictures of throttle positioning sensor... http://www.thepartsbin.com/repsite/ford~throttle_position_sensor~reparts.html