this year of car has no serpentine belt, you should be able to loosen the ac compressor to where it will move to let you remove the belt for this unit after putting new belt on pull back so that you have tension on the belt and have it where you want then re-tighten the bolts you loosened. it should be the same serpentine belt as the alternator. just find the tensioner pulley, take the old belt off and put the new one on.
the 1984 cutlass had a computer but not to the extent of todays cars, I really don't understand your question.
Sometimes the Cutlass sedan and the Delta 88 would share the same wheel design.
under the back license plate
bolt pattern for cheap rims
i think it is under the dash
3and a half in the dash and 4x10 in the trunk
with the proper lift and tires
Gap it at .60
140 B.HP with torque upwards to 200.
Any air shocks are good and will work on your car.
You can find a detailed vacuum hose schematic for a 1984 Oldsmobile Cutlass Supreme in the car's owner's manual. You can also check with local auto stores.
Oldsmobile was a brand of vehicles built by GM. They are no longer build. I own a 1984 Cutlass Supreme in beautiful condition.
inside the nut right before the carb follow the fuel line itll lead you to it
1-6-5-4-3-2 and the dist turns clockwise
The heater core on a 1984 Cutlass Supreme is located under the blower motor on the passenger side of the car, under the hood. First you need to remove the blower, and the hoses connecting the heater core. Replace the core, re-attach the hoses, and put the blower motor back on.
check your drivers door specification decal fotr the tire size.
side floor vents are manually closed, been along time but i think that's right.
get a 4 bbl quadrejet and a interchager.Or put more sqarters into the carb.
If the place where the dipstick for the oil is comes out of the engine it will cause an oil leak. The engine might not be able to build up enough pressure to keep running either on the 1984 Cutlass Supreme. It should be replaced.
4 inch body lift or 6 inch frame lift
it is located on the driver side underneath the engine. its circular in look with two lines one leading to the carburetor. two bolts leading into the engine. also there is a rod inside the mechanical fuel pump.
The 1984 Cutlass is a model of car produced by the company Oldsmobile. The oxygen sensor is typically located near or on the engine block.