I had a hard time getting mine out too. Replaced mine about a year ago. Seeing I was replacing it anyway, I just stuck a thick wrench between the alternator mounts and the alternator and pryed it out. The one I got to replace it was hard to get in, but it turns out the bracket part that slides over the mounts in the car was ever so slightly bent closed. I got another alternator and it slid in properly. I suspect if it's an original alternator it's probably slightly rusted or corroded and making it stick. Before trying to get the new one in, you might wanna sand down the bolt areas and add a little bit of wd-40 to easy installation.
Remove the belt from your Mercury alternator. Remove the wiring harness from the alternator. Remove the retaining bolts. Reverse the process to install your new alternator.
NO!
Begin by removing the belt from your 1999 Mercury Mystique alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.
The Mercury Tracer heater core can be found behind the passenger side kick plate. The heater core can be removed by disconnecting the water supply lines and removing the retaining bolts.
The 1989 Mercury Tracer 1.6 liter engine cylinder head bolt torque specification is 135 pounds. The cylinder head bolts should be torqued in 45 pound intervals.
you loosen the bolts on the opposite sides of it. then, you change the alternater, and tighten the bolts.
the alternator is removed from below and there is three bolts (10 mm socket) that need removed. one of these bolts is on the other side of alternator. use a small mirror to see this bolt. Don't forget to disconnect battery!!!
The alternator on a 92 Nissan Maxima is changed by disconnecting the wiring harness, loosening the retaining bolts, and removing the drive belt. The bolts can then be fully removed and the alternator swapped out.
it's easy to change fan belts that is connected to the alternator two bolts
Disconnect the battery Remove the engine covers to access the alternator drive belts. Remove the electrical connections from the alternator. Slacken the bolts, remove the belt. Remove bolts, put new alternator on, tighten bolts until you can just move alternator, fit new belt, move alternator so the belt is tight and then tighten bolts to their specified torque.
To change the alternator in your 1986 Chevrolet Celebrity: 1, Remove the battery ground cable. 2. Unplug remove the wiring from the alternator. 3. Loosen the bolts that hold the alternator in place. Remove the drive belt. 4. Remove the bolts and the alternator will pull out. Reverse the process to reinstall the new alternator.
If you remove the rear seat cushion you should see a cover with four bolts or screws, under that is the fuel pump.