answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2011-09-13 00:18:41
  1. Disconnect the negative battery cable
  2. Remove the glove box assembly,lower right side instrument panel trim cover and right cowl trim panel,as required.Diconnect the blower lead wire connector
  3. If the car is equipped with air conditioning,disconnect the 2 vacuum lines from the recirculating door acuator and position the actuator aside.
  4. Remove the 2 screws at the top of the blower housing that secure it to the unit cover
  5. Remove the 5 screws from around the blower housing and separate the blower housing from the unit
  6. Remove the 3 screws that secure the blower assembly to the heater or air conditioning housing and remove the assembly from the unit.Remove the fan from the blower motor by removing the spring type retaining ring from the center of the blower wheel.Note the location of the fan-to-blower motor assembly for correct install.
001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


The blower motor is located on the passenger side up under the glove box.


on the 89 dynasty, it is located right next to the thermostat


The blower motor resistor is located under the hood, in the right hand cowl, behind the windshield washer bottle.............


Take out your glove box and a few trim and it will be in front of you


when you turn on blower it makes a strong odor of burning rubber.



They aren't even on the same harness. You likely have two unrelated problems. You can get a wiring diagram for the blower motor by typing in "1992 Dodge Dynasty blower motor" on most browsers. Only thing that can take out unrelated items is a bad ground and in this case that seems highly unlikely.


The blower motor is located on the passenger side of the dash. You will need to remove the glove box and the underdash panel. There are 4 fasteners to the cover, two screws in front and two nuts in the back.


The 1997 Dodge ram blower motor is located on the firewall in the engine compartment. The blower motor will be near the bottom, passenger side, firewall.



For the 1989 Dodge Ram, the heater blower motor resistor can be found on the passenger's side, on the bottom of the heater box. It is beside the blower motor.


Blower motor is under the dash on the passenger side.


Disconnect the battery. Remove the glove box to instrument panel screws. Disconnect the power and ground wires from the blower.. Remove the recirculating door actuator, the seven screws and then remove the complete recirculating housing.. Remove the three blower motor attaching screws.. Remove the blower motor...


Its located under the hood in the right hand cowl behind the windshield washer bottle.........


how do i change my blower motor on my 2007 malibu


Are you asking about the heater blower motor or the engine cooling blower motor?


The resistor is under the passenger dash just left of the blower motor


Only for the high speed. The lower speeds are controlled with the use of a blower motor speed resistor.


Well I Know you must remove the glovebox and ashtray assembly and then you can see the housing but that's as far as I got.


how tdo you change air blower for 1979 camaro



Your truck has both. the resistor is between the switch & blower.thje resistor controls the blower speed


where is blower motor located on 2004 spectra.


i cannot get the wheel off the blower motor


Remove the wiring harness from the back of your 2001 Chevrolet Corvette blower motor. Remove the blower motor retaining bolts. Remove the blower motor fan. Reverse the process to install the new blower motor.



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.