just had something similar like this done, they had to replace the wire harness inside steering wheel, because its all electrical. one of my turning signals and left side of brakes and back window light would not work.
Put the car in drive, unbuckle, and floor the gas pedal. The lights will turn on as needed.
if you are refering to the head lights you need to change the head light bulb otherwise where is the light you are talking about
Possibly a bad ground in the rear wiring harness somewhere.
Replace headlight switch- dimming rheostat may be loose
Is that a question? They work because that's the way your terrible car was designed to work? Do you mean HOW do they work?
They certainly should do. If not, the vehicle should not be driven until they function correctly.
Underneath the glove compartment. By that, I mean you have to pull out the plastic lining in the glove compartment. Stupid, huh?
Remove the 4 bezel trim phillips screws around trim bezel. Unplug headlamp socket. remove headlamp.install new. replace bezel with 4 screws. yur done.
Open trunk and pull carpeting back from the rear lights and you will see wing nuts, take the wing nuts off and pull the complete light assembly out to change the bulbs.
Yes, but the signal lights are the wrong shape.
With the lights on pull on the turn signal lever. High beams should come on. Pull again and they should go off.
Mini-fuse #23 15amp located side instrument panel inside of passenger door . Actual name is- Stop Lamps.