answersLogoWhite
Headlights Tail and Brake Lights
Ford Ranger
Dodge Durango
VW Jetta

How do you change the bulb for the license plate on a 2000 Pontiac Gran Prix?

202122

Top Answer
User Avatar
Wiki User
2006-12-04 16:02:22
2006-12-04 16:02:22

Remove the two screws that hold the cover plate on to the bumper recess and remove the plate. If no cover plate is there, then loosen the screws only. After the plate is removed or the screws loosened what ever you may have on your vehicle just move the housing around the edge of the license plate recess. Turn the bulb assembly 1/4 of a turn counter-clockwise and the bulb housing will come out of the plastic casing. Exchange bulb and reinstall the opposite way.

1

Related Questions

User Avatar

how do you change the light bulb over the license plate on 2000 eclipse

User Avatar

How do you change the lamp on the license plate of a lincoln ls 2000?

User Avatar

Ive been trying to figure this out myself,there's no bulb on mine.An no apparent access to it from outside or the trunk

User Avatar

How do you replace the license plate lights on a 2000 celica?

User Avatar

where are the oxygen sensors on a 2000 Pontiac grand am and how do you change them?

User Avatar

what is the number for the fuse to change the rear license plate light. and is it the fuse box under the back seat or under the hood? The plate light is protected by the parking/tail light circuit.

User Avatar

in the rear facia, under the trunk lid there is 9 bolts holding the facia on. You must remove the nuts and pull the facia out and right above the license is the two bulbs 194. replace the bulbs and put the facia back on and you are on your way.

User Avatar

yes there is, just above rear plate.

User Avatar

change front coil spring on 2000 Pontiac grand am

User Avatar

It is a simple white license plate with California in red cursive writing on the top. (that is the current one which has been used since about 2000 I think)

User Avatar

Just unscrew the two screws that hold on the small clear lens and pop the bulb out.

User Avatar

Phillips screwdriver...two screws throught the lens. Remove the lens and extract the lamp. It pulls out.

User Avatar

where is the freeze plug located in a 2000 pontiac montana mini van

User Avatar

as far as i know ,there is no fuse, it works off lighting curcuit.

User Avatar

If on a trunk lid it may required the removal of several screws and a clear cover just above the license plate.

User Avatar

hello i need you help me tell me how to remove the cover light from a license plate i have a ford focus se 2002 to put a new light thanks willie

User Avatar

Raise the trunk lid...you will see the lights on each side of the license plate...use Phillips screw driver to remove and replace bulb. Just did this takes about 2 minutes.

User Avatar

Please email me a photo of where the blower motor resistor is and how to change it. Thanks, Michael. By the way I want it for a 2000 Sunfire not a Grand Am.

User Avatar

do know where the horns on Pontiac Bonneville 2000 is do know where the horns on Pontiac Bonneville 2000 is

User Avatar

show me where the starter relay is are on a 2000 Pontiac Bonneville

User Avatar

The front speakers on a 2000 Pontiac Grand Am are 4x6. The rear speakers on a Pontiac Grand Am are 6x9.

User Avatar

You don't need to take the whole back panel off to do it!!(learned the hard way) the light cover on the bulb twists out, and it might take some elbow grease to twist it, then the bulb is easy to change.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.