The radio will have to be completely removed from dash and you will a small nut driver to remove the plates on the radio to remove the front panel so you can get to the bulbs to replace them, Unfortunately GM decided to solder each bulb in so be ready for some fun. Or if you are not comfortable doing this the only other solution is to take it to a place that fixes radios to have them replaced.
http://cgi.eBay.com/ebaymotors/GM-Delco-Radio-Display-light-bulbs-10ea_W0QQitemZ130162527716QQihZ003QQcategoryZ33711QQcmdZViewItem#ebayphotohosting
twist and pull out
To change the light bulb for the heater control on the 2006 Tahoe, you will either need to replace the entire climate control panel or remove and re-solder the bulbs. You can remove the bulbs by first removing the dashboard bezel and then the dash itself. Access the bulbs and pull them out of the control panel. Solder new bulbs into the panel.?æ
The bulbs are actually soldered into the circuit board. The only way to change them is to dismantle the whole cluster and desolder then re-solder the bulbs.
Lighted push buttons typically have tiny light bulbs or LEDs inside the buttons. My guess is that the problem is as simple as a few burned out tiny light bulbs.
The small bulbs in the air-condition buttons of a 2001 Nissan Altima are referred to as parking lamps.
Send it to an authorized repair facility, the radio must come apart and then you have to find the bulbs! There are not many facilities will perform the repair as the amount of labor involved usually exceeds the cost of a replacement radio.
There are a couple of reasons why a 1999 Tahoe headlights may not work. A couple of reasons could be blown bulbs or the wiring.
The bulbs are replaceable behind the lens, so the lens (two screws for the front and 4 for the back) must be removed to change the bulbs.
There is a bloke on eBay who sells booklets. A step by step procedure on how to decimantle the dash and put the new bulbs in. He also supplies 4 bulbs. It's about �7.99.
It is practically impossible to reach up behind the dash to change the bulbs. Remove the trim around the instrument panal and you should be able to pull it out enough to change the bulbs. You may have to disconnect the speedometer to get it out far enough.
pull the two rods from the top of the light assembly after raising the hood, this allows you to swing the assembly out and put the new bulbs in
pull the front facia off the heater dials then you find a white box which is to operate the heater dials remove the front from there which is clipped on then there are your bulbs