answersLogoWhite

0

How do you change the clutch cable on a 94 Geo Tracker?

Updated: 10/20/2022
User Avatar

TravisOuzts

Lvl 1
18y ago

Best Answer

This is pretty simple. Disconnect the cable from the transmission then, follow the cable up through the engine compartment disconnecting the plastic clips along the way. Once you get to the firewall, use a socket to remove the two bolts holding it there. Go inside and unhook that end from the clutch pedal arm. Follow this process in reverse to install the new on and you are done!

User Avatar

Wiki User

18y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you change the clutch cable on a 94 Geo Tracker?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you change the clutch cable on a 96 Geo Tracker?

hjfdjdfjgjdf


Where is the clutch reservoir in a Geo Tracker?

it has a cable. will not have a clutch reservoir


Were is the clutch reservoir for the 1995 Geo Tracker?

All 1995 GEO Trackers have a clutch cable that is adjustable instead of a clutch reservior filled with hydraulic fluid.


Where is the clutch reservoir on 1996 Geo Tracker?

The clutch reservoir on a 1996 Geo Tracker is located in the engine compartment, near the firewall. It stores clutch fluid which is pulled into the system as needed.


How do you change the voltage regulator on a 94 Geo Tracker?

To change the voltage regulator on a 94 Geo Tracker, locate it in the black plastic box on the back of the alternator. Unplug each cable from the regulator, remove it and replace.


Where is the clutch sensor on a 1996 Geo Tracker?

on the firewall under the clutch pedal, It is actually a switch


Why wont Geo Tracker clutch disengage?

torque flight transmission


How do you adjust the clutch pedal on your 1994 Geo Tracker?

The clutch cable which runs from the top of the firewall on the drivers side loops around in front and below the engine to a bracket on the passenger side of transmission. there is an adjustment nut there.


How do you change a fuel filter on a 1993 Geo Tracker?

93 tracker


How do you install a new clutch in a 1990 tracker 4 wheel drive?

To install a new clutch in a Geo Tracker, first the negative battery cable must be disconnected and the vehicle lifted on jack stands. After removing the driveshaft and all wiring connections from the transmission, the transmission should be removed. From there, a new clutch disk may be installed.


You have a 1993 Geo Storm and the clutch is very tight What do you need to do?

adjust the clutch cable on top of the trans. adjust the clutch cable on top of the trans.


Where can you get a clutch pedal assembly for a 1990 Geo Tracker 4x4?

Right next to the fountain of youth.