It has a serpentine belt and you have a bolt in the front ( passenger side)of the block that releases the tension on the belt,the tensioner is NOT spring loaded, and remove the belt. Install the new one with the schematic on the fan shroud, If it isn't there draw one before removing the belt. Don't rely on memory. you cannot remember at least if you are old like me LOL
The starter is located under the battery box.
Yes they could leak.
Dexron auto trans fluid.
its one of the 2 located on the right side strut tower in the engine bay
Counter clock wise to loosen.
Anything below .030 A is normal.
no.. very different.. by hard top you mean 4 door..?.. the 4 door window mech is a scissors action.... the convert is on a frame and cabled..
Haynes has produced auto manuals with wiring and engine schematics and diagrams for the LeBaron. Haynes Automotive Repair Manual 25020 covers LeBaron Landau & Sedan for 1990 thru 1993. Haynes Automotive Repair Manual 25030 covers LeBaron Coupe/Convertible and LeBaron GTS for 1982 thru 1995, as well as LeBaron Sedans for 1982 thru 1989. You can purchse the books at Haynes online (www.haynes.com).
The motors on the rear quarter windows are unreliable.. same thing happened to my lebaron. you have to push them down and move it back and forth. but be careful as to not break it or put too much pressure on it. That worked for me.
If the problem started after you replaced a fuse, you need to check that the fuse is good and installed properly.
You can change the headlight, on your 1990 Chrysler LeBaron, by removing the headlight retaining screws. Remove the wiring harness. Reverse the process to install the new headlight.
Yes, there is a transmission in a 1990 Mazda RX7 convertible.
Yes, it fits (if both are 4 bangers or if both are V6)
From inside the trunk.
Its in the fuel tank
if you mean from the fuel tank to the engine bay.. the line runs under the car on the drivers side.. the fuel pump is located inline just past the drivers door on a convertible..
Chrysler does not have reset switches.
If they are discs they would be solid