Honda Accord
Honda Accord EX
Honda Accord LX

How do you change the fast idle sensor valve on a 1991 Honda Accord EX?

456

Top Answer
User Avatar
Wiki User
Answered
2008-05-14 17:52:40
2008-05-14 17:52:40

well the fast idle thermo valve ,is on the top of the motor right on the intake manifold,it has two screws on the top, let engine warm up , take the screws out. put finger over and gently push ,with engine running. If no air flow replace valve,or unscrew the plastic top of valve, and with sand paper placed face up on a flat surface sand down bottom of valve. This will let the heat reactive part of the valve shut of sooner blocking the excess air from entering the intake manifold and raising idle.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


"What is the valve clearance on 1992 Honda accord?"

The Oxygen sensor of a 89 honda accord lxi fuel injection 2.0 valve engine is located in front of the engine on the manifold .

What do a pc vale do in a Honda Accord

Where is the location of my vent valve solenoid 98 honda accord ex v6

The expansion valve, on your 1998 Honda Accord, is located just before the thermostat housing. You can follow the water hose from the radiator to the expansion valve.

How much does it cost parts and labor to replace a valve cover gasket on a 1990 Honda Accord 4door.

To do a valve lash on a 2003 Honda Accord make sure a lash gauge is on hand. Valves lashes adjust the valve to piston clearance on cars. Be sure to use the appropriate specifications of clearance for the 2003 Accord.

The idle air control valve controls the neutral idle of the 2001 Honda Accord. A faulty idle control valve leads to an erratic idle. To replace it first locate the valve on the intake manifold. Unplug the unit and remove the three bolts holding it to the manifold.

Hi- your pcv valve is located right in the center of the valve cover (usually black cover that says Honda on it)

The valve adjustment specs on a 1993 Accord are as follows Intake-0.0008 to 0.0018 inch Exhaust-0.0022 to 0.0031 inch these specs are for the 1993 Accord ONLY!! if you have a 1990-1992 these specifications change.

The 1996 Honda Accord is an interference engine so in almost every case you will have valve and possibly piston damage if the cam belt breaks.

Local shop told me that there's no need to do valve adjustment on 2003 Accord.

How do you change the ac expansion valve on a 2001 Honda civic

The PCV Valve is located in the Vaccum line above the alternator.

I want to know the number for the valve lash adjustment.

The EGR valve for a Honda EX 1991 is at the top of the engine. It is at the front, just to the left of center.

Valve lashes only need to be done when the valve piston clearance inside the engine is off. Factory service manuals will list the appropriate clearance levels for the 2003 Honda Accord.

same as you do on the ford question below your question here. And that goes for all the other types of vehicles you have.

Remove the transmission pan on the bottom of the transmission. The filter is mounted to the valve body of the transmission.

The expansion valve on a 1997 Honda Accord AC is located in line with the tube that supplies liquid coolant to the air conditioner vapor. It is mounted right beside the tube.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.