Auto Parts and Repairs
Heater Cores and Blower Fans
Chevy Blazer S-10
Ford Bronco II

How do you change the heater core in a 1990 Mercury Topaz?

474849

Top Answer
User Avatar
Wiki User
2015-07-15 18:31:06
2015-07-15 18:31:06

BIG JOB Get a manual on your car from the parts store and it wil have pictures .

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Simply take the old ones loose with the clamps and put new ones on. You may want to replace the clamps .

User Avatar

The blower is behind the glove box. Remove the glove box door, and there it is. Some small sockets will be in need. It will come out if you wiggle it around.

User Avatar

you can see that in www.tempotopaz.com and many other things about it

User Avatar

I have the same problem hope someone tells us what to do Mel

User Avatar

Just follow the top rad hose. It's in the housing.

User Avatar

on autozone .com on autozone .com on autozone .com

User Avatar

If its just the cord, then follow the old cord to the back side of the engine ( really the side of the engine closest to the firewall ) and replace it. When the engine is cold, plug it in and you will hear the block heater heating up. If you don't hear anything, then replace the heater also. That requires a little more knowledge.

User Avatar

how do i change the heater core in a 1990 Eddie Bauer

User Avatar

It's the pully that's the only one you can actually work on toward the fire wall, it will be on top.

User Avatar

.054 inch ( according to www . ford parts . com , no spaces )

User Avatar

sounds like you are too far down the launch ramp or you live in a really wet area ..

User Avatar

If it is the same engine, both either standard or auto, might have to check if the 1990 had over drive, cause the 88 or most of them did not.

User Avatar

Look to the left of steering wheel,under the lower dash panel.Be prepared to be a contortionist.Just one of Fords better ideas.

User Avatar

If it is early 1990's the fuel filter is in engine compartment on right hand side if your looking undeer hood. It is a big silver thing mounted to the firewall. There is just 2 clips holding it on ( top and bottom) when you get new filter it will have these clips.

User Avatar

For a 1995 Marquis it requires a skilled mechanic several hours to drop steering column, remove entire dashboard, disconnect airbags, just to get to the heater core.

User Avatar

how can i find where the camshaft sensor on a 1990 mercury marquis

User Avatar

YES Some were all wheel drive. Allthough both front & rear are limited slip, & the rear only if the front wheels are spinning.

User Avatar

Your Ford/Mercury dealer can get the code. See "Related Questions" below for instructions on changing the lock cylinder

User Avatar

.054 inch , according to fordparts.com

User Avatar

How to find your fuse box on a 1990 Mercury Topaz. 1) Get a double-jointed: spine, neck, arms (both), and possibly fingers (all 10). You'll need them. 2) Look down and to the left of the steering column, behind your hood release switch. YOu'll probably have to lie on your back and slide to where your pedals are to find it. 3) E-mail mquell29@gmail.com telling him which fuse is for the power/automatic seatbelts. 8 wrong fuses and counting...

User Avatar

the fuel filter on the 92 topaz is located on the right inside fender, on the 90 it may be in the same place, if not you can follow the fuel line from the gas tank to the front of the vehicle and it should be visible.

User Avatar

In order to change the heater core on an 90 ls400 you have to remove the entire dash pad and cross bar to be able to remove the heater core box. This is a job for and experienced LEXUS technician www.lextechautomotivellc.com

User Avatar

This process could take up to 3 hours. The Heater core is best flushed if you are having problems with flow. Is this an option? F. Garay


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.