Remove the horn pad. - screws on back side Remove the c-clip at the center of the wheel. Remove the large nut. Remove the steering wheel - A steering wheel puller is best, but if not available - locate your hands on the dash side of the steering wheel, palm side up (facing you). Bring your hands toward you, hitting the back of the wheel with constant firm hits (left palm, right palm, left palm...) You may want to wear gloves, but trust me this works (I repoed for many years) Once the wheel is off you will see a torque screw holding the ignition in place. Remove the screw and the ignition will pull right out (towards the passenger door). Just put the new one in, replace the torque screw and put everything back in reverse order. CAUTION: If the torque screw is left out the ignition will just pull out. CAUTION: If the c-clip is left off, the nut will back off and the steering wheel will fall off. This may sound complicated, but once you start, you will see it is very easy. Good Luck and make sure you put everything back.
change the Ignition Lock lock switch
How do I replace an Ignition in a 1970 Maverick
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
The ignition switch should be separate from the ignition key/lock assembly, so I'll say no.
On most cars, yes.
how to change igntion lock
Do you mean the electrical ignition switch or the cylinder lock and key..?
Turn the key to acc. and push the plunger in located on the Ignition lock housing
Answerput your ignition key in the lock turnit to accesory, there will be a small pinhole you will have to stick a pin of some sort in there and then it should just pop right out.
http://youtube.com/watch?v=D3o4IuScZZI
Remove the retaining ring at the top of your Chevy S 10 ignition lock cylinder. Slide the ignition lock cylinder out. Remove the wiring harness from the back of the ignition lock cylinder. Reverse the process to install the new ignition lock cylinder.
there is a little green ignition switch, this is whats used to turn engine on and off. a metal block goes onto this and then the actual lock barrel goes onto here