answersLogoWhite

0


Best Answer
Copy

Unscrew the door handle. Unscrew the "cup" you pull on to close the door. Unscrew the rest of the screws around the bottom and rear of the door panel. Slide the door handle sideways and pull it free. You will need to unclip the long metal rods from the back of the handle, which may be easier with your arm inside the door panel.

Put it back the opposite of how you took it apart.

Stocker @ http://www.rdtiburon.com/
David @ http://votefordavid.blogspot.com

User Avatar

Wiki User

โˆ™ 2009-11-18 04:52:48
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Add your answer:

Earn +5 pts
Q: How do you change the inside door handle on 1999 Hyundai Elantra 4 door 4 cylinder?
Write your answer...
Submit

Related Questions

How do you replace the inside door handle on a Hyundai elantra?

How_do_you_remove_a_door_panel_and_handle_to_repair_the_window_in_a_'00_Hyundai_Elantrathis might help..


How do you replace the external door handle on a 2001 Hyundai Elantra?

* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car


How do you replace exterior driver door handle on 2001 Hyundai elantra?

* To remove the outside door handle and lock assembly raise the window and remove the door trim panel and watershield * Working through the access hole disengage the plastic clips that secure the outside handle to latch actuating rod and the outside door lock to latch actuating rod * Working through the access hole remove the outside door handle retaining bolts * Remove the handle/lock cylinder assembly from the car


In a 2000 Hyundai elantra you have every gear exept overdrive what could be the problem?

Could be the overdrive on/off switch, which is located on the gearshift handle. That's all the help I can give you, best of luck.


How do you replace a 2001 Hyundai elantra front outer door handle?

1. Raise the window and remove the door trim panel and water shield 2. Working through the access hole disengage the plastic clips that secure the outside handle-to-latch actuating rod and the outside door lock-to-latch actuating rod 3.working through access hole remove the outside door handle retaining bolts 4. Remove the handle/lock cylinder assembly from the vehicle


How do you wire a trailer connector for a 2003 Hyundai Elantra?

I have read that you need a "powered" wiring harness because the Elantra routes the tail lights through a computer that cannot handle the extra amperage necessary to drive a trailer's lights. A powered harness connects directly to the battery for power and taps the tail-light wires to control relays.


What is trumpet look like?

it is a long bronze cylinder-like item with a pull handle and buttons to change the noise


How do you remove front door panel on Hyundai elantra?

what year? i have a 2007 and I'm trying to find out the same thing. I know there's a screw hiding under a cap in door handle, then the bottom will pry outeard. Not sure about the top half though


How do you repair a door handle on a 2002 Hyundai Accent?

Take it to a dealer


How do you replace an interior door handle on a Hyundai?

The interior door handle on a Hyundai latches onto the locking mechanism of the door. First remove the old handle by unscrewing it from the door panel. Pull the handle out and remove the locking wire. Install the new unit with the locking mechanism in place. Tighten the mounting screw.


How do you change a 1999 Hyundai interior door handle?

This is for a 1999 Hyundai Elantra Wagon. The general process may be similar between models, however I am not sure. 1. There is a screw in the middle of each handle, take this screw out and put it somewhere you won't lose it. 2. With the screw removed, the handle can be popped out of the panel about a centimeter. 3. Slide a flat-headed screw driver into the gap you've just created, above the handle. Inside the door there are two metal rods which have a 90 degree bend at the end of them which slides into the handles. There is a plastic clip on each rod that secures it in place on the handle. With the screw driver, pop the clips off of the rods. 4. With the clips off, the rods are held in place within the handles only by friction. The plastic handles are not very strong, so be careful while prying the rods out of the handle. 5. With the rods removed, the handle should be completely removed. To install the new handle, simply trace your steps backwards.


Where is the overdrive switch on a 2001 Hyundai tiburon?

It is located on the gear shift handle.


How do you remove passenger side window crank handle on a 1998 hyandai elantra?

There is a clip holding the handle. It is located in the center in the back of the handle. There is a tool to remove & install it; but you can use a flat screwdriver carefully. Good luck.


How do you replace the driver side exterior door handle on a 1998 Hyundai Accent?

take it out


How do you remove window crank handle in 1999 Hyundai accent?

With a hammer and pry bar.


Name parts of a glue gun?

Cylinder, trigger, handle.


How do you remove the driver side door handle on a 99 Hyundai accent?

It is held in place by two screws, remove them, pull the handle towards you and that should do it.


How do you remove the window handle on a 1999 Hyundai Excel?

Push the door panel in around the window handle and use a screwdriver or a piece of wire with a hook to pull the clip off....it's in behind the handle.


Where is the 2007 Ford Fusion transmission dipstick located on the 4-cylinder?

Near the battery, small red handle.


How can you replace a door handle on a 2003 Hyundai Tiburon?

The 2003 Hyundai Tiburon has door handles that sometimes break or need replaced. They can be easily removed and replaced with a new part.


What is wrong with a 2000 Hyundai Elantra when the od off sign is on and how can you fix it?

There's a click on/off switch for the O/D located on the gear handle, just below the big button that you push in to shift out of park. I hit it with my knee all the time. If you put your head under the steering wheel (easiest with the driver door open) and look at the gearshift handle from down there, you can't miss it. It's the only other button on it.


How do you change the door handle on a Hyundai excel sprint 1996?

you need to first take off the interior side of the car door so you can get to the bolts that are holding the handle in place. there are two - one on either side of the handle and they can be difficult to remove. you need to make sure that you also pull out the key barrell from the old door handle by taking off the u clip holding it in place and there is also the connection wire from the interior handle to the exterior door handle that needs to be removed also. to put the new handle in remember to connect the wire for the interior handle and the key barrell then you can bolt the handle back in place.


Change shift handel 2000 Chevy Malibu?

Yes, you can change the shifter handle. Remove the hairpin clip at the front side of the handle and lift the handle from the metal pipe.


2004 elantra wiper delay does not work motor good replaced handle fast and slow works wipers don't work when pull back on handle for washer washer works?

have u fitted the exact same handle? somethimes they are different even from same year of car...


How too take off the door panel handle off of a 2003 Hyundai tiburon?

hammer PS use the right to