The upper ball joints must be replaced with the upper control arms but the lower ball joints can be replaced seperately. NOTE: THE BEST WAY TO GET THEM OUT IS TO KNOCK THEM OUT WITH A 3LB MINI SLEDGE HAMMER FROM AUTOZONE.
According to my Haynes repair manual it states that 1995 and newer models upper and lower balljoints are not removable or serviceable. If a balljoint is damaged or worn, replace the control arm.
how do you change a fuel pump on a 1999 ford explorer
"0" play in lower ball joints
which ones? upper or lower?
The 1999 Ford Explorer has a cam chain not a belt. No maintenance is required.
On a 1999 Ford Explorer ( using the factory jack ) Front tire ( there are " hooks " on the front of the lower control arms ) Rear tire ( under the axle tube , below the leaf spring )
Lower rear end of engine
Two ball joints - one on each side.Until the advent of McPherson struts, there used to be upper and lower ball joints. The struts eliminate the uppers, so now there is only the lower.Note: ball joints on a 1996-1999 Taurus/Sable are a real bear of a job!See "Related Questions" below for more
sounds like your ball joints
no 4 cylinder not firing 1999 for explorer vidsio
My Haynes repair manual ( 1991 thru 2001 Ford Explorer ) shows on 1995 and newer that the balljoints on upper and lower control arms are not removable or serviceable . If a balljoint is damaged or worn , replace the control arm . ( my Chilton repair manual also shows the same information )
ball joints upper and lower control arm
There are 2 U joints on a 1999 Ford expedition. There is an U joints on each end of the driveshaft.
Instualation of a heater core on a 1999 Ford Explorer V6, how do you install the heater core.
The smallest engine in a 1999 Ford Explorer is the 4.0 liter V6
No , the 1999 Ford Explorer Sport and the 1999 Ford Explorer 4 door have shock absorbers front and rear
where is the horn located on a 1999 ford explorer?
freon for 1999 ford explorer =========================== r134a ( Helpfull )
Typically the squeaks in the front end mean you need to replace the ball joints. I recommend doing both upper and lower ball joints at the same time.
I need an exploded veiw of a 98 z71 front end gear box
look for a botton on the rightside of the dashboard that says 4x4 or look under the front suspension and see if it has cv-joints.
Remove the wheel. Remove the brakes and drum. Remove the tie rod. Pound the ball joint out with a hammer. Reverse the process to install the new ball joints.
5 quarts with engine oil filter change
There is just a rear one I believe, on top of differential
No , the fuel tank has to be dropped to change the fuel pump