CAPACITIES
Engine, with Wix Filter 51040..........4.5 quarts
TORQUES
Oil Drain Plug.....18 ft-lbs
All you'll need are a few simple tools, enough cans of oil for your particular vehicle, and approximately 20 minutes. Needed Equipment: * Oil Filter Wrench I prefer "Strap Wrench which can be used on oil filters up to a 6" (152mm) diameter. It Strong nylon belt will not slip. Use with 1/2" square drive tools." See link to Wrench below. * As many quarts of oil as your car needs. Refer to your owner's manual for recommendation. * Oil Drain Pan (for draining the old oil into). An something like a gallon milk jugs with screw on lids work great to transport to recycle center or you can purchase an all in one. See link to Oil Pan below. * Wheel ramps * Blocks to wedge behind your tires * Proper size wrench * Funnel * Rags * A new oil filter to fit your make and model Changing the Oil: * Place the wheel ramps under your front tires and drive up on them. * Put on your emergency brakes and place the blocks behind your back tires. * To drain the old oil out of your car, crawl underneath and find the plug on the bottom of your oil pan. * Place your container under the pan and use your wrench to unscrew the plug. * Caution: The oil may be hot and could cause severe burns! Also, the oil will pour out quickly after the plug is removed; let it drain completely. When the oil has stopped draining, replace the plug. Replacing the oil filter: * Make sure you rub a little clean oil on the gasket of the filter to help seat properly. * Find the Oil Cap on the top of the engine it says Oil. * Using the funnel, fill the car up with as many quarts as it requires. Last Final check: * Once you've added the oil, start the engine while the car is still up on the ramps and let it run a bit, checking for any leaks around your oil filter and oil pan plug. * If you see oil leaking, tighten up the filter some more. * Drive your car off the ramps. ALWAYS dispose of used oil properly, preferably at a location that recycles oil.
what is the spark plug gap for a 98 Chevy lumina sedan 3.1Liter engine
There are four motor mounts located on a 1990 Chevy Lumina. Two on either side of the engine. One the rear and one in front of the engine.
The 1995 3.4L is NOT an interference engine. Change belt every 60,000 miles. The 1996-97 3.4L is an interference engine.
How do you replace the blower motor on a 1994 chevy lumina euro?
To replace timing chain on a 3.1 Chevy Lumina engine, you need to first make sure that your motor or engine is turned off. Then you need to remove the chain and replace it.
Remove the wiring harness from the back of your 1998 Chevy Lumina heater motor. Remove the heater motor retaining bolts. Remove the fan from the front of the heater motor. Reverse the process to install the new heater.
you have to take the motor brackets that hook the motor to the front of the car and then roll the engine forward carefully to get to the back three plugs.
the blower motor for a 92 lumina is under the dash on the passenger side...my husband had to change the motor in out car a few months back.... right under the glove box
the beretta and lumina motors are about the same i have a lumina motor in my 95 beretta
you dont rotate it you have to pull the altnator off to change them
If they are both 3100 engines...yes. Direct swap. The only thing you MAY have to change would be the motor mounts.
The length of the transmission dipstick that goes in a Chevy LuminaÊ3.1Êmotor is 24 inches. This is a common size for the 3.1 engine.