Place a tub under the drain plug which is located on the side at the rear of the engine. Remove the plug, let fully drain, then remove the oil filter located on the drivers side of the engine. Screw on the new filter, don't forget to replace the drain plug, then refill with engine oil. Run the engine for a few seconds and then check the oil level again because the oil filter will need to fill with oil as well. Good luck!
For a 1994 Ford Ranger , 4.0L V6 engine : The PREFERRED oil is 5W-30 With engine oil filter change ( 5.0 U.S. quarts / 4.7 litres )
For a 1994 Ford Ranger , 3.0 liter V6 engine : ( 5W-30 is the PREFERRED oil )
Can the oil pump be replaced on 1994 Ford Ranger 4.0 without pulling motor?
With engine oil filter change ( 5 quarts )
underneth the intake underneth the intake
Remove oil pan
It should be located in the oil pan. On my ranger its on the drivers side.
oil sensor on your oil pan is bad.
Yes
With engine oil filter change : The ( 4.0 liter V6 engine ) takes ( 5 quarts/4.7 liters ) The other size engines I do not know
4 or 5 quarts
Have to drop oil pan